Fostex LM16 manual Condensation, Cleaning the exterior, About damage, About CAT-5 cable

Page 8

Model LM16 [Introduction/Overview]

Condensation

•When temperature and humidity change suddenly (for example, when you move the LM16 from a cold place to a warm place), moisture condensation may occur to the display and panel.

In such a case, leave it with the power turned off for some time until the moisture evaporates.

Cleaning the exterior

•For normal cleaning, use a soft dry cloth. For stubborn dirt, moisten a cloth in diluted detergent, wring it out firmly, and wipe the dirt off.

Then polish with a dry cloth. Never use solvents such as alcohol, thinner or benzene, since these will damage the printing and finish of the exterior.

About damage

•Fostex is not responsible for any “direct damage” or “indirect damage” caused by using the LM16.

About CAT-5 cable

•Use only a CAT-5 STP cable for connection between the main unit and the control unit.

<Note>: Do not connect or disconnect a CAT-5 cable while the LM16 is powered on. When you connect or disconnect a CAT-5 cable, make sure that the LM16 is powered off.

8

Image 8

Contents Model LM16 Safety Instructions Important Safety Instructions Table of contents Signal flow of the mixer Connecting sources Adjusting the input level Low-cut filter Limiter EqualizerUpgrading the software About power supply Precautions on installationAbout version upgrade IntroductionCleaning the exterior CondensationAbout damage About CAT-5 cableOverview Main features Before using the unit Unpacking the cartonSetting the main unit and control unit separately Usage examples of LM16Integrating the main unit and control unit Mounting the main unit and control unit on the rackIntegrating the control unit and main unit Necessary itemsRack mount adaptor After attaching the adaptor Connecting the power cord Preparation of power supplyConnection to external devices Connection example live stageConnection example home recording MTRBalanced and unbalanced inputs/outputs BalancedNames and functions Control unit input channel 1 through POST/PRE switch Mute switch14 ST/1-2/3-4 assign switches Solo switchMonitor section Control unit Master channelSUB in jacks / SUB in control Control section Phantom 1-8, 9-16 indicatorsInternal effects section AUX Send controls / Solo switches 24 27 EFF Send control / Solo switchAssign to Stereo OUT switches Output Limiter switchControl unit rear panel Main unit rear panelPhantom 1-8, 9-16 switches Controller connectorGroup OUT 1, 2, 3, 4 connectors Stereo OUT L, R connectorsSignal flow of the mixer Mixer basicsConnecting sources Adjusting the input levelConnecting sources to the input connectors Phantom power supply settingGain adjustment while monitoring EqualizerLow-cut filter LimiterUsing an external effect processor Using AUX 1, 2Pre-fader Post-faderApplying the internal effects Using the internal effects processorUsing Insert Monitoring About the effect typesChannel grouping Solo monitorSet the ST assign switches on channels 15 and 16 to on Using SUBSet the Source switches on channels 15 and 16 to TRK Block diagram Showing date information Showing version informationR peak indicators R meters between 7Specifications Inputs/OutputsPhysical dimensions Power Consumption approx WGeneral Main unitMMC Command List Midi Implementation Chart Model LM16Declaration of EC Directive Forthe US Customers only Fostex America Limited Warranty Shipping Index Effect processorMemo Page Fostex CO