Dynacord DRM 4000 owner manual Using The Unit Together With The DPM

Page 17

SPECIAL FEATURES OF THE DRM 4000

6.4 Using The Unit Together With The DPM 4000

The DRM 4000 is an ideal inputs extension for the DPM 4000. Audio connections between the two units are established using balanced cables with XLR-type connectors.

Using the optionally available RS-485 remote-interface NRS 90256 allows connecting the DRM 4000 to the DPM 4000 for control purposes. This allows using the DPM 4000’s Designer software to comfortably control, configure and save the following parameters: routing, ducking control, preset switching, output levels control.

6-2

Image 17

Contents

DRM For US, Canada and Japan only Safety Component has to be Replaced with Original Part onlyContents Characteristics Introduction DRM 4000 CharacteristicsIntroduction Field of ApplicationUnpacking and Warranty Controls and Connections Controls and Connections12, POWER-switch Ducking indicators a / BTone Control LO / HI Control AUX18, Direct OUT 16, Control27, +24V-switch 26, PAD-switch20, Send output 21, MIX in inputQuick Start Uick StartInstallation and Connections Installation and ConnectionsGeneral Notes Input Assignment 1 MIC/LINE inputsOutput Assignment 4.3.1 Master outputs AUX and MIX in inputsSend outputs Direct OutputsExternal VCA-Control Control InputsControl Inputs Level Settings Power-On OperationLevel Adjustment for MIC/LINE-inputs Initial OperationLevel Adjustment for AUX-inputs Special Features of the DRM Special Features of the DRMUsing Ducking Control Limiter OperationUsing The Unit Together With The DPM Software Editor DRM Installation NotesSoftware Editor DRM System RequirementsMenus And The Toolbar File Menu Software Description 7.4.1 GeneralView Menu Basic ConfigurationCommunication Menu About MenuMIC/LINE-inputs Name and CommentAux-inputs OutputsPriority Test Online Control / StatusControl Inputs View Status N Figuring the DRM Configuring the DRMBasic Configuration Internal Configuration Possibilities Internal SettingsInternal Settings / Extensions Low Cut Filter AUX Sensitivity Selection Limiter SettingsHow to install the Input Transformer NRS 90233, EDP-No HOW to Install ExtensionsHow to install the Output Transformer NRS 90227, EDP-No How to install Interface-Boards Peci F I C a T IO N S SpecificationsSpecifications Specific a Tions User ConfigurationSpecifica Tions Block diagram 10.4 RS-232 Interface Programmer’s Instructions Switching Contacts Via SoftwareREMOTE/PRIO value Online-Access to all ParametersDimensions Garantie Warranty