![](/images/new-backgrounds/1199576/19957645x1.webp)
SOFTWARE EDITOR DRM 4000
7.4.5 Online Control / Status
This window allows remotely controlling and monitoring the DRM 4000 in real-time. It also offers the possibility to test the active control input configuration without the need for additional hardware. An active RS-232-connection between your computer and the DRM 4000 is necessary to be able to access this functionality. For details on individual parameters, please refer to chapter 8 “BASIC CONFIGURATION”.
Control Inputs
View Status
Activating “View Status” displays for all parameters the momentarily active state of the DRM 4000. The green LED’s next to the corresponding soft keys indicate the momentarily active control inputs.
Test
Activating “Test” allows the simulation of setting control inputs by pres- sing the according soft keys. The green LED’s next to the corresponding soft keys indicate the momentarily active control inputs and parameter fields as well show the actual active status of the DRM 4000. The mixer behaves as if a control input had been set via hardware. As long as the DRM 4000’s test mode is active, actually setting control inputs via hardware does not show any effect. When canceling the RS-232-con- nection between computer and DRM 4000, automatically cancels the test mode after approximately 3seconds. The DRM 4000 returns to normal operation mode.
Remotely controlling the DRM 4000 is independent of the fact whether “View Status” or “Test” has been activated or not, as long as the RS-232 connection is active.
DRM
For US, Canada and Japan only
Safety Component has to be Replaced with Original Part only
Contents
Field of Application
Introduction DRM 4000 Characteristics
Characteristics
Introduction
Unpacking and Warranty
Controls and Connections
Controls and Connections
Control AUX
Ducking indicators a / B
12, POWER-switch
Tone Control LO / HI
18, Direct OUT
16, Control
21, MIX in input
26, PAD-switch
27, +24V-switch
20, Send output
Quick Start
Uick Start
Input Assignment 1 MIC/LINE inputs
Installation and Connections
Installation and Connections
General Notes
Direct Outputs
AUX and MIX in inputs
Output Assignment 4.3.1 Master outputs
Send outputs
External VCA-Control
Control Inputs
Control Inputs
Initial Operation
Power-On Operation
Level Settings
Level Adjustment for MIC/LINE-inputs
Level Adjustment for AUX-inputs
Limiter Operation
Special Features of the DRM
Special Features of the DRM
Using Ducking Control
Using The Unit Together With The DPM
System Requirements
Installation Notes
Software Editor DRM
Software Editor DRM
Menus And The Toolbar File Menu
Software Description 7.4.1 General
About Menu
Basic Configuration
View Menu
Communication Menu
Outputs
Name and Comment
MIC/LINE-inputs
Aux-inputs
Priority
Test
Online Control / Status
Control Inputs View Status
N Figuring the DRM
Configuring the DRM
Basic Configuration
Internal Configuration Possibilities
Internal Settings
Internal Settings / Extensions
Low Cut Filter
AUX Sensitivity Selection
Limiter Settings
How to install the Input Transformer NRS 90233, EDP-No
HOW to Install Extensions
How to install the Output Transformer NRS 90227, EDP-No
How to install Interface-Boards
Peci F I C a T IO N S
Specifications
Specifications
Specific a Tions
User Configuration
Specifica Tions
Block diagram
10.4 RS-232 Interface Programmer’s Instructions
Switching Contacts Via Software
REMOTE/PRIO value
Online-Access to all Parameters
Dimensions
Garantie
Warranty