![](/images/new-backgrounds/1199576/19957641x1.webp)
SOFTWARE EDITOR DRM 4000
Name and Comment
Here one can provide each contact and the basic configuration with a name and with a comment.
MIC/LINE-inputs
-Label: provides the possibility to assign individual names to corresponding the MIC/LINE-inputs.
-Routing: allows assigning the microphone/Line-level input signal to output A (Mono A), output B (Mono B), both outputs (Dual) and none of the outputs (Off).
-Priority Override: the first two microphone/Line-level inputs offer the possibility for automatically controlled attenuation of the input channels that are assigned to the identical output (ducking control); i.e. the input signal of the first two input channels controls the output level of the other channels. Enabling or disabling the function is possible.
Note:
Ducking and Priority Override settings can be made on the front panel of the DRM 4000. For further detail, please refer to the corresponding chapter of this owner’s manual.
Aux-inputs
-Label: provides the possibility to assign individual names to the corresponding Aux-inputs.
-Routing: allows assigning the Aux-signal to the outputs A and B in stereo quality. Assigning the monaural summed L/R-signals to output A (Mono A), output B or to both outputs (Dual) is likewise possible. The input signal is not assigned at all when set to OFF.
Outputs
-Label: provides the possibility to assign individual names to the corresponding outputs.
-Mute: allows muting / un-muting the corresponding output signal.
-Duck: activating this function (ducking) attenuates the levels of the non-prioritized channels by a value previously set value on the front panel of the DRM 4000.
-Level: allows lowering a corresponding channel’s level by a value of up to
90 dB. Setting is possible via soft fader or using the UP/DOWN buttons.
DRM
For US, Canada and Japan only
Safety Component has to be Replaced with Original Part only
Contents
Characteristics
Introduction DRM 4000 Characteristics
Introduction
Field of Application
Unpacking and Warranty
Controls and Connections
Controls and Connections
12, POWER-switch
Ducking indicators a / B
Tone Control LO / HI
Control AUX
18, Direct OUT
16, Control
27, +24V-switch
26, PAD-switch
20, Send output
21, MIX in input
Quick Start
Uick Start
Installation and Connections
Installation and Connections
General Notes
Input Assignment 1 MIC/LINE inputs
Output Assignment 4.3.1 Master outputs
AUX and MIX in inputs
Send outputs
Direct Outputs
Control Inputs
Control Inputs
External VCA-Control
Level Settings
Power-On Operation
Level Adjustment for MIC/LINE-inputs
Initial Operation
Level Adjustment for AUX-inputs
Special Features of the DRM
Special Features of the DRM
Using Ducking Control
Limiter Operation
Using The Unit Together With The DPM
Software Editor DRM
Installation Notes
Software Editor DRM
System Requirements
Menus And The Toolbar File Menu
Software Description 7.4.1 General
View Menu
Basic Configuration
Communication Menu
About Menu
MIC/LINE-inputs
Name and Comment
Aux-inputs
Outputs
Priority
Online Control / Status
Control Inputs View Status
Test
N Figuring the DRM
Configuring the DRM
Basic Configuration
Internal Settings
Internal Settings / Extensions
Internal Configuration Possibilities
Low Cut Filter
AUX Sensitivity Selection
Limiter Settings
How to install the Input Transformer NRS 90233, EDP-No
HOW to Install Extensions
How to install the Output Transformer NRS 90227, EDP-No
How to install Interface-Boards
Specifications
Specifications
Peci F I C a T IO N S
Specific a Tions
User Configuration
Specifica Tions
Block diagram
10.4 RS-232 Interface Programmer’s Instructions
Switching Contacts Via Software
REMOTE/PRIO value
Online-Access to all Parameters
Dimensions
Garantie
Warranty