Dynacord DRM 4000 owner manual How to install Interface-Boards

Page 31

INTERNAL SETTINGS

9.3.3 How to install Interface-Boards:

RS-485 Interface (NRS 90256, EDP-No. 121 785)

RS-232 Interface (NRS 90258, EDP-No. 121 790)

Contents NRS 90256:

1 x Notes leaflet NRS 90256

1 x Printed board assembly 80475 including blind for the rear panel and connection cord 2 x Locking-screws

Contents NRS 90258:

1 x Notes leaflet NRS 90258

1 x Printed board assembly 80479 including blind for the rear panel and connection cord 1 x 3,5" Disk with Software DRM 4000 Editor

2 x Locking-screws

Installation Instructions NRS 90256, NRS 90258:

1.Turn off the power of the DRM 4000 and open the cover plate as described before.

2.Loosen the blind on the rear panel (2 screws on the rear).

3.Install the extension printed board assembly replacing the blind.

4.Tighten the two screws on the rear panel.

5.Connect the printed board assembly to the connection board CN10 on the printed board 80478 (MAIN BOARD) using the supplied 20-pole connection cord.

6.Reinstall the cover plate as described above and switch the power on. Upon switching the power on, the newly installed interface-board is automatically recognized.

9-6

Image 31

Contents DRM For US, Canada and Japan only Safety Component has to be Replaced with Original Part onlyContents Field of Application Introduction DRM 4000 CharacteristicsCharacteristics IntroductionUnpacking and Warranty Controls and Connections Controls and ConnectionsControl AUX Ducking indicators a / B12, POWER-switch Tone Control LO / HI18, Direct OUT 16, Control21, MIX in input 26, PAD-switch27, +24V-switch 20, Send outputQuick Start Uick StartInput Assignment 1 MIC/LINE inputs Installation and ConnectionsInstallation and Connections General NotesDirect Outputs AUX and MIX in inputsOutput Assignment 4.3.1 Master outputs Send outputsControl Inputs Control InputsExternal VCA-Control Initial Operation Power-On OperationLevel Settings Level Adjustment for MIC/LINE-inputsLevel Adjustment for AUX-inputs Limiter Operation Special Features of the DRMSpecial Features of the DRM Using Ducking ControlUsing The Unit Together With The DPM System Requirements Installation NotesSoftware Editor DRM Software Editor DRMMenus And The Toolbar File Menu Software Description 7.4.1 GeneralAbout Menu Basic ConfigurationView Menu Communication MenuOutputs Name and CommentMIC/LINE-inputs Aux-inputsPriority Control Inputs View Status Online Control / StatusTest N Figuring the DRM Configuring the DRMBasic Configuration Internal Settings / Extensions Internal SettingsInternal Configuration Possibilities Low Cut Filter AUX Sensitivity Selection Limiter SettingsHow to install the Input Transformer NRS 90233, EDP-No HOW to Install ExtensionsHow to install the Output Transformer NRS 90227, EDP-No How to install Interface-Boards Specifications SpecificationsPeci F I C a T IO N S Specific a Tions User ConfigurationSpecifica Tions Block diagram 10.4 RS-232 Interface Programmer’s Instructions Switching Contacts Via SoftwareREMOTE/PRIO value Online-Access to all ParametersDimensions Garantie Warranty