Denon DN-X1600 owner manual MIC mic input, Ducking function, Monitor headphones output

MIC (mic input)

1When a microphone is connected to MIC1 or MIC2, press the MIC1 or MIC2 button to set it to ON.

2Adjust the MIC1 volume level using the MIC1 TRIM control, and adjust the MIC2 volume level using the

MIC2 TRIM control.

•While inputting audio signals, if the SIG/PK LEDs occasionally light up red and then amber, the suitable level has been reached without any distortion.

3Adjust the sound quality using the MIC EQ controls (HI, LOW).

4To add the effect functions to the mic input, press the MIC EFX INS buttons to switch them ON.

Ducking function

To enable the ducking function, set the DUCKING

5 button to ON. The button will light.

• This function detects the mic input and attenuates the level of the music signals in the master output. It prevents the sound from the microphone from being drowned out by the music when a microphone is used.

• The attenuation level of the master output while the ducking function is operating can be set within a range from –30 dB ± 10 dB in the Utility mode.









ENGLISH

MONITOR (headphones output)	Getting
Select the source to be monitored using the CUE	Started
1 buttons for each channel.
• When selected, the CUE button lights.
	Connections
• CUE monitors for channels 1–4 as well as EFX can be
selected.
Use the SPLIT CUE button to select the STEREO/
2 SPLIT CUE mode.
	Basic
• When selected, the SPLIT CUE button lights.
	Operations
• In the SPLIT CUE (monaural) mode, the signal selected
for cue is output to the left speaker of the headphones,
and the master signal is output to the right speaker of the
headphones.
	Effector
• In the STEREO mode, the master signals and signals
selected for cue are output in stereo.
	Function
3 the CUE signals and master output signals.
Use the PAN control to adjust the balance between
• When it is turned to the left, only the CUE signals are
	Fader
output from the headphones.
• When it is turned to the right, only the master signals are	Start
output.
Use the LEVEL control to adjust the headphone	USB
4 output level.
NOTE	Utility
To prevent hearing loss, do not raise the volume level excessively
	Specifications
when using headphones
	Troubleshooting

11