Crossfader Start
1Using the SOURCE SEL controls, select the source from LINE1 CD, LINE2 CD, LINE3 CD and LINE4 CD.
2 Set the CROSSFADER ASSIGN switches (A/ THRU/B) to A or B.
3Turn on the CROSSFADER START switches.
4 Slide the Crossfader all the way in direction opposite the source you want to start.
(In the following example, startup is done with the CD player connected set to Assign A.)
5Set the standby mode on CD player.
6Use the CROSSFADER CONTOUR control to control the cross fader startup curve.
7 When the Crossfader is slide in the opposite direction, CD player play will begin.
FADER (setting the fader curve)
This adjusts the rise response of the channel fader/cross fader.
1Setting the channel fader curve
•When the channel fader CONTOUR control is turned to the left, the curve will have characteristics that rise gradually.
•When turned to the right, it will have characteristics that rise sharply.
•At the center position, curve characteristics between the two will be produced.
•The same curve characteristics apply to channels 1 to 4.
2Setting the crossfader curve
•When the crossfader CONTOUR control is turned to the left, the curve will have characteristics that rise gradually.
•When turned to the right, it will have characteristics that rise sharply, and
•At the center position, curve characteristics between the two will be produced.
ENGLISH
How to adjust the Crossfader torque | Getting | |||
| ||||
1 Remove the rubber cap of the front panel. | Started | |||
| Move the Crossfader to the far right until the screw | Connections | ||
2 head becomes visible. |
| |||
|
| |||
3 | Insert a screwdriver, and adjust the sliding torque. | Basic Operations | ||
Effector | ||||
The sliding torque is increased so that | the Crossfader | |||
• When the screw is turned clockwise: |
|
| ||
| moves more stiffly. |
| Function | |
| • When the screw is turned counterclockwise: | |||
|
| |||
| The sliding torque is decreased so that the Crossfader |
| ||
| moves more easily. |
| FaderStart | |
4 rubber cap onto the front panel. | replace the | |||
| After completing the adjustments, |
| ||
NOTE |
| USB | ||
|
| |||
• The Crossfader has a | Utility | |||
the screw with too much force or loosening it excessively may result | ||||
| ||||
in damage or adversely affect performance. |
|
| ||
|
|
| Specifi | |
| Rubber cap |
| cations | |
|
|
| ||
| Screwdriver |
| Troubleshooting |
15