3. SPEAKER-LEVEL OUTPUTS
These output connections provide
Only passive loudspeakers should
be connected to these speaker- level outputs.
The outputs can be selected with the amp mode switch (12) to be either the stereo main mix, or the mono main mix on output A, and the monitor mix on output B.
Two common types of connector are provided for your convenience: Speakons® and 1/4" TS.
Mono Speakon Connection
1–
1+
COLD
1–
4. VENTILATION
Do not obstruct these ventilation slots, or the internal amplifi ers may overheat and shut down.
Allow at least six inches of free space behind the powered mixer when in use.
HOT 2+
1+
2–
•Speakon outputs are wired Pin 1+ positive (hot) and Pin 1– negative (cold).
1/4" TS Connection
SLEEVE | SLEEVE TIP |
TIP
TIP |
SLEEVE |
•1/4" TS outputs are wired Tip positive, and Sleeve negative.
These two types of outputs are wired in parallel, and it is possible to use both types at once.
The minimum impedance that
the powered mixer can handle
is 4 ohms per channel, and we recommend that you do not go
below this. If you are using both output styles per channel, make sure each loudspeaker is 8 ohms impedance or greater.
11