Getting Started, Setup, Connections, Other Notes

Getting Started

We realize that you must be really keen to try out your new powered mixer, but please read the safety instructions on page 2, and this page ﬁ rst.

SETUP

1.Place the powered mixer in a position where it is easy to reach the controls. All the controls and input connections are located on the front panel so you can make quick adjustments and connections on stage.

2.Make sure there is at least 6 inches of airspace behind the powered mixer for ventilation. Use the powered mixer in a nice clean and dry environment.

CONNECTIONS

1.Be sure the rear-panel power switch is off before making any connections.

2.Push the linecord securely into the IEC connector on the rear panel, and plug the other end into a 3-prong AC outlet that is properly conﬁ gured for the voltage of your powered mixer.

3.Plug a balanced microphone into one of the mic XLR (3-pin) connectors on the front panel. Or you can connect a line-level source (keyboard, or guitar preamp) to a line input jack using a TRS 1/4" plug.

4.You will need a DI box to connect guitars/instruments to the powered mixer.

5.Plug your passive speakers (4 ohms or greater) into the speaker output jacks on the rear panel. If you plug two speakers into a side, each speaker must be 8 ohms or greater to maintain a 4- ohm minimum load on the ampliﬁ er. Use at least 18 gauge speaker cable with 1/4" TS plugs or Speakon® plugs. For now, set the power amp mode switch to stereo mains.

Don’t use guitar cords for speaker

cables! They’re not designed to handle speaker-level signals and could overheat.

READY, STEADY, GO!

1.Turn down all the channel level, mon, and FX controls.

2.Set all the EQ controls to the center, including the graphic EQ sliders.

3.Turn down the main master level and monitor master level controls, and turn on the powered mixer.

4.For condenser mics, push in the phantom power switch. If you are using both condenser and dynamic mics, don’t worry. Phantom power will not hurt most dynamic mics. Check the microphone’s user manual if you’re not sure.

5.For each channel 1-6, press the gain switch in (low gain) if you are using a line-level source. Press it out (high gain) if you are using a microphone or other low-level source.

6.Play something into an input at real- world levels, and turn up the channel level to U (unity).

7.In normal playing, the channel's OL LED should only light occasionally. If it stays on for a large portion of your performance, check that the gain switch is set correctly.

8.Slowly turn up the main master level control until you hear the signal in your speakers.

9.Repeat steps 5 to 7 for the remaining channels.

10.If needed, apply some EQ wisely.

11.Adjust the levels to get the best mix. Keep the level controls fully down on unused channels.

Other Notes

•Only connect the powered mixer's speaker-level outputs to passive loudspeakers.

•When shutting down, turn off any external ampliﬁ ers or powered loudspeakers ﬁ rst. When powering up, turn on any external ampliﬁ ers or powered loudspeakers last.

•Save the shipping box!