Roland VS-1680 owner manual Copying data to another location Copy, Target

Editing an automix

fig.4-05_80

Target

This will indicate the type of automix data that you selected to be erased in step 6. If you wish to erase all automix data, use the TIME/VALUE dial to select “All Level and Pan.”

10.If you wish to erase the data, press [F4 (Exec)]. If you press [F6 (EXIT)], you will return to step 7 without erasing any data.

11.A message will ask you to confirm the operation. Press

[YES]. If you press [NO], the erasure will be halted, and you will return to step 10.

fig.4-06

12.When the data has been erased, the display will indicate “Complete.” Press [PLAY (DISPLAY)].

Copying data to another location (Copy)

This operation copies automix data from a specific area, and overwrites it onto another location (specified data/time).

3.Press [PAGE] so that [F5] indicates “A.Mix,” and then press [F5 (A.Mix)].

fig.4-02

4.Press [F2 (Micro)].

5.Press [PAGE] so that [F1] indicates “In.”

fig.4-03

6.Make sure that the cursor is located at “Edit Target,” and use the TIME/VALUE dial to select the type of automix data that you wish to edit.

7.Use [][] to move the cursor to the first marker of the area from which you wish to copy automix data, and press [F1 (In)].

fig.4-07.e

					Destination
		Copy area			Marker
0 M0			M2	M4	Time	0 M0		M2 M4		Time
	M1		M3	M5			M1	M3	M5

NOTE

Editing of the automix data cannot be cancelled by the Undo function (VS-1680 Owner’s Manual, p. 160).

1.Press [PLAY (DISPLAY)].

2.Hold down [SHIFT] and press [F6 (UTIL)].

8.Use [][] to move the cursor to the last marker of the area from which you wish to copy automix data, and

press [F1 (Out)]. A check mark will be added to the copy area.

fig.4-04.e

Check marks

20