Roland VS-1680 owner manual Recovery procedure, +Verify, X2 353 KBps X1 176 KBps

Page 27
Backup at double speed (353 kilobytes per second).
Backup at normal speed (176 kilobytes per second). This will increase the reliability.

Using the VS-1680 with a CD-R/CD-RW drive

+Verify

If this is turned “On,” verification will be performed to check whether or not the data was saved correctly after the song data has been backed up.

CD Speed

Select the speed at which the song data will be backed up to the CD-RW disc

x2 (353 KBps):

x1 (176 KBps):

NOTE

Depending on the disc, it may not be possible to back up reliably to a CD-R disc with a setting of “x2 (353 KBps).” In such cases, select “x1 (176 KBps).” Also, if you insert a CD-RW disc into a CD-RW drive, it will not be possible to select “x1 (176 KBps)” (backup will occur at double speed).

7.If two or more drives are connected, you can press

[F5 (SelDr)] to see a list of the drives. After checking the list of drives, press [F1 (Back)].

fig.5-09_70

8.Press [F4 (Exec)]. A message will ask you to confirm.

fig.5-10

9.Press [YES]. The display will ask “STORE Current?” (store the current song?)

10.If you wish to save the current song, press [YES]. If not, press [NO]. If a protected song (such as a demo song) is selected, press [NO].

11.If the amount of song data is too large to back up onto a single CD-RW disc, the CD-RW disc will be ejected, and you will be prompted to “Insert Disc #” (where # is number of each disc in the series), so that the VS-1680 can verify the number of discs that will be required. Insert the next CD-RW disc, and press [YES]. At this time, we recommend that you use a soft-tipped felt marker pen to write the disc number on the disc label so that you can

remember the sequence in which each disc should be inserted.

fig.5-11

12.If the backup extends over two or more discs, the display will prompt you to “Insert Disc #.” Insert each disc once again in the correct sequence, and press [YES]. Then, backup will begin.

13.When the CD-R backup ends, you are returned to Play condition.

Restoring songs from a CD-RW disc (Recover)

Specifying the speed of recovery (Speed)

Now you can specify the speed at which the data will be read when recovering a song from a CD-RW disc.

Recovery procedure

1.Select the loading destination (recovery destination) drive as the current drive.

2.Insert the CD-RW disc that contains the song backup into the drive.

3.Press [PLAY (DISPLAY)].

4.Hold down [SHIFT] and press [F6 (UTILITY)].

28

Page 26 Page 28
Image 27
Page 26 Page 28
Contents 01898978 ‘99-3-E3-11T Table of Contents Precautions Enhanced operations Additional effect algorithmsAutomix editing functionality Enhanced support for CD-R/CD-RW drivesExpanding the functionality of the VS-1680 If you purchasedIf you purchased the V-XPANDED system program Zip disk Expanding the functionality of the VS-1680 Cannot be used Mix 16 tracks down to 2 tracks Mastering RoomAdded mastering tracks Mixing down to the mastering tracksMarker StatusTrk L track L Trk R track R After Rec after recordingSignal flow routing Mixdown shortcutPlaying back the mastering tracks Mixing down while inserting effects Rtn effect return level EFX1 effect insert switchOff Rec Snd effect send levelHold down STOP, and press Status for all tracks New effects algorithms EQ EqualizerExpander Compressor Mixer Exp Expander BCut Bass-cut filterEnh Enhancer InputOut Output Cmp CompressorMix Mixer Lmt LimiterModeling various speakers Speaker Modeling SpMod speaker modelingLFT/HFT Frequency trimmer Release Effective ways to use speaker modelingErasing data from a specific area Erase Editing an automixTarget Copying data to another location CopySmooth data transitions Gradation Destination TargetDestination Mark Value Gradation CurveMarker Add Press page so that F5 indicates A.Mix, and then Increasing or decreasing all data values Shift/ExpandExpand ShiftThreshold Using the VS-1680 with a CD-R/CD-RW drive Song writing procedureSpecifying the writing speed Speed Finalize Write MethodCD Speed Backup procedure Specifying the speed of saving SpeedSource Song Recovery procedure +VerifyX2 353 KBps X1 176 KBps Erase All Songs Attention Sorting the take list Sort Enhancements related to operationShortcut to the Phrase Edit window Creating a new phrase Phrase NewDeleting a take Delete TakeTrack 1090 Naming a take Name14.e OUT Threshold Dividing a phrase into two parts Phrase SplitType MarginDivide Split To to point Group Linking the faders of two or more channels Fader GroupCopying mixer settings F4 Exec or Enter YESF6 Exit or Exit no Shift Lock on/off SHIFT+YES Removing direct current offset from the mix busDC Cut Checking inserted effects Icon and Patch Name display Enhancements to the display and specificationsEasy Routing Additional template Mastering Switching the Song Select window List displaySettings not stored in a scene Monitor Level Master Send switch display has been changed Pan→ MIXImmediate application of step-edited changes Index SymbolsInformation
Top Page Image Contents