5. ERGO Calibration Software (ERGO Cal)
5.2Calibration
Speaker Mode
This window will inform you of which, if any, buttons are selected on
Don’t be scared. Overwriting measurements helps ERGO clear its thoughts and prepares it to take new measurements. Selecting CANCEL sends you to the initial window. If there is something you want to reconfigure at this point, then select CANCEL. If not, click Enter to continue. (Figure 5.6)
Figure 5.4
Subwoofer Mode
If you chose to use ERGO in Subwoofer mode, the next window gives you a thumbs up to proceed, or tells you to press any required buttons. When given the prompt, click Enter. (Figure 5.5)
Figure 5.5
Tip To enable the Subwoofer mode, remember to open the ERGO Control Panel and click A + SUB from the Speaker Mode area.
Figure 5.6
This pretty much speaks for itself. (Figure 5.7)
Figure 5.7
18