KRK ERGO manual Ergo Control Panel Description

Page 16

4. ERGO Control Panel Description

This section describes ERGO’s Control Panel including configurable parameters and system information. (Figure 4)

ERGO Info

This is a read-only display that indicates the current system firmware revision, DSP firmware revision, and your FireWire ID. SPDIF Status

This display lights to indicate ERGO’s sample rate. Audio Settings

Use the associated pull down boxes to select ERGO’s sample rate (Figure 4.1) and ASIO buffer size (Figure 4.2).

Figure 4

Note Remember that ERGO Control Panel is available for Windows only. Go to Start > Programs > KRK ERGO and click ERGO Control Panel to open it.

Speaker Mode

Allows you to select to use only your A speakers, A and B, or A and Sub(s) (referred to as Subwoofer mode).

Subwoofer Settings

If selecting Subwoofer mode, use this section to adjust your crossover settings.

Tip Remember that in a speaker crossover network, the crossover frequency is the frequency point that represents the upper or lower range limits of a given speaker driver. In a two-way speaker system, the crossover frequency would be the point where the low frequency driver begins to roll off and the high frequency driver starts to cut in.

Figure 4.1

Note Reducing the buffer size can decrease the amount of latency while monitoring and recording audio. Increasing the buffer size can reduce and /or eliminate some audio artifacts such as pops and clicks while recording.

Figure 4.2

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Page Contents Introduction Introduction Mac OS X 10.5 or later. PC Introduction Ergo Panels and Connections SpdifErgo Panels and Connections Ergo Panels and Connections Setting up Ergo and your Mixing Environment Focus1 / Listening Position Adding a Subwoofer Setting up Ergo and your Mixing Environment Setting up Ergo and your Mixing Environment Setting up Ergo and your Mixing Environment Ergo Control Panel Description Ergo Calibration Software Ergo Cal Calibration Speaker Mode Ergo Calibration Software Ergo Cal Ergo Calibration Software Ergo Cal Tick tock, tick tock... Figure Ergo Calibration Software Ergo Cal Room Correction Then, click YES to store your measurements Figure Ergo Calibration Software Ergo Cal Using Ergo in several DAW Environments Foolproof set upUsing Ergo in several DAW Environments Generic DAW Configurations Specific DAW Configurations Audio Device, select Ergo Asio NuendoTroubleshooting Calibration Mic level is not loud enough Troubleshooting Specifications Appendix Glossary of Terms Appendix Glossary of Terms LITK00027 REV-A 8/22/2008
Top Page Image Contents