Teac Gf-680 Discs which can be played on this unit, CD-RW discs cannot be played on this unit

Page 5

Discs

Discs which can be played on this unit:

Conventional audio CDs bearing the CD-DA logo on the label:

?

Properly finalized CD-R discs

Note:

<Depending on the quality of the disc and/or the condition of the recording, some CD-R discs may not be playable.

<CD-RW discs cannot be played on this unit.

<Copy-protected discs and other discs which do not conform to the CD standard may not play back correctly in this player.

If you use such discs in this unit, TEAC Corporation and its subsidiaries cannot be responsible for any consequences or guarantee the quality of reproduction. If you experience problems with such non-standard discs, you should contact the producers of the disc.

<Always place the disc on the disc tray with the label side uppermost. (Compact discs can be played or recorded only on one side.)

<To remove a disc from its storage case, press down on the center of the case and lift the disc out, holding it carefully by the edges.

How to remove the disc

How to hold the disc

<Should the disc become dirty, wipe the surface radially with a soft, dry cloth.

<Never use such chemicals as record sprays, antistatic sprays or fluid, benzine or thinner to clean the discs. Such chemicals will do irreparable damage to the disc's plastic surface.

<Discs should be returned to their cases after use to avoid dust and scratches that could cause the laser pickup to "skip."

<Do not expose discs to direct sunlight or high humidity and temperature for extended periods. Long exposure to high temperatures will warp the disc.

<CD-R discs are more sensitive to the effects of heat and ultraviolet rays than ordinary CDs. It is important that they are not stored in a location where direct sunlight will fall on them, and which is away from sources of heat such as radiators or heat-generating electrical devices.

<Printable CD-R discs aren't recommended, as the label side might be sticky and damage the unit.

<Do not stick papers or protective sheets on the discs and do not use any protective coating spray.

<Use a soft oil-based felt-tipped pen to write the information on the label side. Never use a ball-point or hard-tipped pen, as this may cause damage to the recorded side.

<Never use a stabilizer. Using commercially available CD stabilizers with this unit will damage the mechanisms and cause them to malfunction.

<Do not use irregular shape CDs (octagonal, heart-shape, etc.). CDs of this sort can damage the unit.

<If you are in any doubt as to the care and handling of a CD-R disc, read the precautions supplied with the disc, or contact the disc manufacturer directly.

ENGLISH

5

Image 5
Contents GF-680 Pour le Canada For U.S.AFor Canada Sony Corporation Label required in this regulation is shown ① ① For U.S.AType SLD104u Before Use ContentsCD-RW discs cannot be played on this unit DiscsDiscs which can be played on this unit Tape Handling Cassette TapeTape Selection Installing new stylus How to Replace the StylusHandling Records Removing old stylusBottom of the unit Installing the legsDVD, CD-R, etc AC Power Cord Remote Control UnitBattery Installation FM antennaY X W Names of Each Control Front Panel/Remote Control Unit Names of Each Control Turntable How to open/close the turntable coverHeadphones Eeps Electronic Equalizer Preset SystemBasic Operation MutingSelect the speed Put the record on the turntable Listening to a RecordPress the AUX/PHONO button Rotation stops Tone arm Cue lever Turn the Volume knob to adjust the volumeTurntable will begin to turn Press the PLAY/PAUSE button to start playback Listening to CDsPress the OPEN/CLOSE button to close the tray To stop playback To suspend playback temporarily pause modeTo skip to the next or a previous track Search for a part of a trackPress the Program button Programmed PlaybackTo check the programmed order Intro CheckTo add a track to the end of the program To overwrite the programShuffle Playback Intro in the stop modeRepeat Playback Repeat one trackIf the reception is poor FM Mode buttonHow to select preset stations Preset TuningMemory indicator blinks Preset channelFast forward and rewind Listening to TapesPress the STOP/EJECT button to stop playback Press the Play button to start playbackRecording Tape II only Extended PlaybackCD Synchronous Recording Load a recordable cassette tape into Tape @Press the Tape button or the Function button to select Tape Dubbing Copy from Tape I to TapeHigh NormalHold up or down the knob to set the current hour Setting the ClockAdjust the clock before setting the timer Setting the TimerTimer OFF indicator appears on the display Within 5 seconds, press the Clock ADJ buttonPress the Timer button Timer PlaybackTimer indicator appears on the display Press the Power switch to turn the unit off standbyWhen the unit is on Timer RecordingWhen the unit is off DisplayCD Player TroubleshootingTuner Cassette Tape DeckSpecifications Avant lutilisation SommaireMise en garde sur la condensation EntretienDisques CD-R correctement finalisés DisquesDisques pouvant être lus avec ce lecteur Choix de bande BandesManipulation des bandes Nettoyage du chemin de bandeManutention des disques Installation dune nouvelle aiguilleComment remlacer laiguille AvertissementFond de lunité Installation des piedsBranchement Commutateur Reset Boîtier de télécommandeAntenne FM Cordon dalimentation CATélécommande Nomenclature Panneau avant/Télécommande Comment ouvrir/fermer le couvercle de la platine Nomenclature table tournanteEeps Système d’égalisation électronique pré-réglé Opération de baseSourdine Système de rehausse des gravesVisse Adapteur 45 RPM Écoute de disqueChoisir la vitesse AttacheLa table tournante commence à tourner Tournez le bouton du Volume pour régler le volumeAppuyez sur la touche OPEN/CLOSE pour fermer le tirroir Écoute de CDSi il ny a pas de disque, no Disc clignote La lecture commence automatiquementPour arrêter la lecture Pour suspendre la lecture momentanément mode pausePour sauter vers la piste précédante ou suivante Recherche dune section dune pisteLecture programmée Vérification de lordre de programmation IntroPour ajouter une piste à la fin du programme Pour ré-écrire un programmeRépétition de la lecture Lecture aléatoireRépétition dune piste Répétition de toute les pistes de tous les disquesSi la réception est mauvaise Touche FM ModeÉcoute de la radio Comment choisir des postes pré-réglés Syntonisation pré-régléeLe témoin Memory clignote Canal pré-régléAvance rapide et rembobinage Écoute de bandesAppuyez la touche STOP/EJECT pour arrêter la lecture Appuyez la touche Play pour engendrer la lectureEnregistrement Tape II seulement Lecture continuEnregistrement synchronisé dun CD Chargez une bande enregistrable dans Tape @La copie se fait à une vitesse normale Copiage Copiage de Tape I à TapeHeure clignote Réglage de lhorlogeAppuyez la touche Clock ADJ Minute clignote Réglage de la minuterieRéglez lhorloge avant de régler la minuterie Timer est affiché Appuyez la touche TimerLecture minutée Minutes clignoteAfficheur Enregistrement minutéDurant la lecture dun CD Quand lappareil est alluméLecteur CD DépannageSyntonisateur Platine à cassetteSpécifications Teac Corporation