Altinex MT109-102 manual ?CnUi, ?Ui, Sta

MULTI-TASKER™

4.[?CnUi]

This command will return general information about the card and its status. It is a function of both the card and the front panel and is only available with Multi-Tasker™ Front Panel systems that have the following firmware:

690-0122-015 = Version 015 or later.

690-0123-004 = Version 004 or later.

690-0124-018 = Version 018 or later.

NOTE: In MTSetup™, send the command [VER] from the Terminal Window. The system will respond with feedback similar to the following:

[690-0122-015 690-0123-004 690-0124-018]

Check the last three digits against the numbers above to determine if the option is available.

Command Format: [?CnUi]

Cn = Card ID (n = # from 1 to max slots)

Ui = Unit ID (i = from 0 to 9)

The MT109-102is in slot #4. Send the command [?C4] to receive the feedback status.

Each status field begins with a '+' and ends with the card slot number (ex: C04). The feedback will be similar to the following:

[+MT109-102C04+VR690-0133-008C04 +VO16C04+VI161616C04+VB08C04+VT08C0 4+VL01C04+VM0C04]

MT109-102	= Card Type
VR690-0133-008	= Firmware version
VO16	= Output Volume Level=16
VI161616	= Input volume levels
VB08	= Bass level = 08 out of 16
VT08	= Treble level = 08 out of 16
VL01	= Loudness (00=ON, 01=OFF)
VM0	= Mute (0=OFF, 1=ON)

The Input Volume status line is read from left to right as outputs one through three. Each volume level is 2 digits, in this case, each is set to 16.

5.[?Ui]

This command will return general information about the Multi-Tasker™ and cards installed in the unit.

Command Format: [?Ui]

Cn = Card ID (n = # from 1 to max slots)

Ui = Unit ID (i = from 0 to 9)

Example:

A Multi-Tasker™ with ID #0 has a front panel with part number MT101-102 and contains an MT109-102. Send the command [?] and receive the following feedback:

[+MT101-102U0+MT109-102C04]

MT101-102U1 = Panel Number and Unit ID MT109-102C04 = An MT109-102 is in slot 4.

6.[STA]

This command enables/disables automatic feedback from the front panel. The command affects any card with auto-feedback capability, not just the MT109-102.The default at power on or reset is STA0, OFF.

Command Format [STA1] = ON Command Format [STA0] = OFF

Feedback Prefix Definitions: +VR = Firmware Version +VO = Output Volume +VI = Input Volume +VB = Bass Volume +VT = Treble Control +VL = Loudness Control +VM = Mute Control

Example:

Command = [VLOA12C04]

Feedback = [+VO12C04]

+VO = Output Volume

12= Output volume level12

C04 = Card slot number

400-0343-003 10

10