7.[…S] – SAVE
This command will save the configuration
command being sent in memory. When sending the command [VLBA12C4S], after reset or power up, the bass level on C4 will be 12 out of 16.
8.[…F] – FEEDBACK
After processing a command, an OK or ER will be returned as feedback if "F" is included at the end of some command strings.
9.[ + ] and [ - ]
These commands allow a selected property to be adjusted from keyboard commands or programmed front panel buttons.
Command Format: [ + ], [ - ]
[+]= Increment level by one step
Example:
Select the Output Volume command for the card in slot #4. The current Output Volume level is 10, but it is not the optimal value. After sending the following commands, an optimum volume level of 15 is obtained:
1.[SELOC4]
The current volume level is 10.
2.[ – ] [ – ] [ – ]
The level is now 7 and is too low.
3.[+][+][+][+][+][+][+][+]
The level is now 15 and no further adjustments are required.
10.[SELIm]
This command sets the path to adjust the INPUT volume level. The input volume range is 00 to 16 and is adjustable using the [+] and
Command Format: [SELImCnUi]
m = Input (m = # from 1 to 3)
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
An
11.[SELO]
This command sets the path to adjust the OUTPUT volume level. The output volume range is 00 to 16 and is adjustable using the [+] and
Command Format: [SELOCnUi]
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example 1:
An
Example 2:
The output volume may also be adjusted using key ramping commands. See the VOLUME RAMPING FEATURE section of this manual for details on using this feature.
12.[SELB]
This command sets the path to adjust the bass level. The BASS level range is 00 to 16 and is adjustable using the [+] and
Command Format: [SELBCnUi]
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
11 |
11