Altinex MT109-102 manual Precautions / Safety Warnings, General, Cleaning, FCC / CE Notice

Page 3

MULTI-TASKER™

PRECAUTIONS / SAFETY WARNINGS

1

Please read this manual carefully before using your MT109-102. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your MT109-102and to prevent fire and shock hazard. Please read them carefully and heed all warnings.

1.1 GENERAL

Qualified ALTINEX service personnel, or their authorized representatives, must perform all service.

To prevent fire or shock, do not expose this unit to rain or moisture. Do not place the MT109-102in direct sunlight, near heaters or heat radiating appliances, or near any liquid. Exposure to direct sunlight, smoke, or steam can harm internal components.

Handle the MT109-102carefully. Dropping or jarring can damage the card.

Do not pull the cables that are attached to the MT109-102.

Insert the card carefully into the slots of the Multi-Tasker™ without bending any edges.

1.2 CLEANING

Clean only the connector area with a dry cloth. Never use strong detergents or solvents, such as alcohol or thinner. Do not use a wet cloth or water to clean the card. Do not clean or touch any component or PCB.

1.3 FCC / CE NOTICE

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their expense.

Any changes or modifications to the unit not expressly approved by ALTINEX, Inc. could void the user’s authority to operate the equipment.

400-0343-003

2

2

Image 3
Contents MT109-102 Troubleshooting Guide FCC / CE Notice Precautions / Safety WarningsCleaning GeneralAbout Your MT109-102 Technical SpecificationsDescription of MT109-102 Diagram 1 Typical Setup Application DiagramDiagram 2 Internal View SW6 Diagram 3 Switch Positions INPUT1 INPUT2 INPUT3 Line OutputSW1 OFF SW2 SW3 SW4 SW5RS-232 Control Installing Your MT109-102Description of Commands OperationCnS VER?CnUi ?UiSTA SELIm SeloSelb Vlba SeltVloa VLIxAmRUP Volume Ramping FeatureLOD1 CLRRamp RDNRDN=xx RSTMemory is Good Card ID CommandsRamptime = 16 Seconds TestSID+ RSISIDn SIDnCiRMC RSNHelp 36. WRCLM RMG39. RD ClrgSelb STASeli SeloMenu Mode Menu Command DefinitionsUsing Menu Mode 4 MT109-102 Menus Menu TypesMain Menu SUB MenusClear VolumeMT109-102 Expanded Menus Control this Card SaveSelect this Card for control Menu Mode ExamplesSet Input 3 Volume Set Output VolumeTroubleshooting Guide LED is not onNo Sound Sound Level is LOW Limited WARRANTY/RETURN PolicyAltinex Policy Sound Distortion