2 |
60 cm |
60 cm |
3 |
60 cm |
60 cm |
Wall-mounting (only for type HD 3275)
This model can be used as a
This wall should be solid, flat and fireproof.
- Using a small |
screwdriver push the |
small lip downwards |
6 |
Only for type HD 3275:
If the heater is going to be used in the bathroom, it
must be installed...
-so that switches and other controls cannot be touched by a person in the bath or shower;
-outside the colour indicated areas (figs. 2 and 3).
Storing the mains cord
Excess mains cord can be stored by pushing it into the storage compartment at the back of the heater.
Please Note: Do not use the appliance when the mains cord is kept inside the appliance.
Type HD 3274:
-You can fix the mains cord by pressing it into one of the three slots (F).
(fig. 4) and remove |
the heater from the |
stand / wall bracket |
(fig. 5). |
- Use the stand / wall |
bracket as a template |
to mark the drilling |
holes (fig. 6). |
7 |
8 |
4 |
5 |
-Drill the holes and fix the stand / wall bracket to the wall using screws and rawlplugs (fig. 7).
-Slide the appliance correctly onto the stand / wall bracket (“Click!”) (fig. 8).
How to use
The selector switch (C) and the thermostat knob
(D) enable you to select the following functions:
Type HD 3275:
-Using a small screwdriver push the small lip downwards (fig. 4) and remove the heater from the stand / wall bracket (G) (fig. 5).
-You can fix the mains cord by pressing it into one of the three slots (F).
-Slide the appliance correctly onto the stand / wall bracket (“Click!”) (fig. 8).
Selector switch (C)
O= "Off”. Both the fan and the two heating elements are switched off.
>= “Cool air”. Only the fan is switched on.
1 = "Warm air"for gradual
ECO positon (half power): the fan and one of the two heating elements are switched on.
2 = "Hot air" for quick
Full power: the fan and the two heating elements are switched on.
5