Peavey Duel 212 Master Volume, Standby Switch, Active LED, Power Switch, Power LED/ON, Line Cord

Page 5

MASTER VOLUME (21)

Controls the overall volume level of the system. Once a desired balance of the clean and lead channel volume levels is achieved, the entire system level may be increased or decreased with the Master Level Control.

STANDBY SWITCH (22)

Allows amp to be placed in standby or active mode. In standby mode the tubes remain hot, but the amplifier is not operational. Eliminates warm up time, allowing the tubes to remain hot and ready for instantaneous operation.

ACTIVE LED (23)

The active LED indicator light will illuminate when the amp is in the operational mode. The standby switch (22) should be switched to the active mode in order for the amp to be operational.

POWER SWITCH (24)

Supplies power to the unit. Depressed to the “ON” position, the power LED indicator (25) will illuminate indicating power is being supplied to the unit.

POWER LED/ON (25)

Illuminates when AC Power is being supplied to the amp when the power switch (24) is depressed to the “ON” posi- tion.

1

GND

 

 

0 5

PRFAMP

0

0

 

 

8

 

 

 

 

 

120 “AC

 

 

 

LEVEL

SEND RETURN

 

 

 

 

 

bO HZ

 

rUSC

REMOTE SWITCH

-wx-

400 WATTS

 

5A

 

 

 

SPEAKER OUTPUTS -f

12OW RMSI44” RMS 40 MIN SPEAKER JACKS PARALLELED

-1

LINE CORD (1)

(12OV units only) For your safety, we have incorporated a three-wire line (mains) cable with proper grounding facili- ties. It is not advisable to remove the ground pin under any circumstances. If it is necessary to use the amp without proper grounding facilities, suitable grounding adaptors should be used. Greatly reduced shock hazard exists when the unit is operated with the proper grounded receptacles.

GROUND SWITCH (2)

Three position, rocker-type switch which, for most applications, should be operated in the center (zero) position. If hum or noise is noticed coming from the speaker with the ground switch in the center position, place the ground switch to positive or negative (+ or -) to minimize hum. Should a hum/noise problem continue, consult your authorized Peavey dealer, the Peavey factory, or a qualified service technician.

NOTE: The ground switch is not functional on 220/240 volt models.

FUSE (3)

A 5 amp fuse is located within the cap of the fuse holder. Tt must be replaced with the same type and value in order to avoid damage to the equipment and to prevent voiding the warranty. If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair. WARNING: The fuse should only be replaced when the power cord has been disconnected from its power source.

REMOTE FOOTSWITCH JACK (4)

Provided for the connection of the supplied remote footswitch. Footswitch is used to select the channel from clean to lead and to select the effect, reverb, and tremolo on or off.

LEVEL (5)

Adjusts the voltage level of the effects loop. If the send level is too low for a particular effects device, turn the control clockwise; if too high, counterclockwise.

EFFECTS SEND (6)

Output for supplying signals to external effects or signal processing equipment.

5

Image 5
Contents Page Page LOW Gain Input High Gain InputGain LOW, MID, & High EQBoost Switch Bright SwitchClean LED Lead LEDStandby Switch Master VolumePower Switch Power LED/ONEffects Return Impedance Selector SwitchPreamp OUT Speaker OutputsPreamp Section Power Amplifier SectionTone Settings ECUALIZACI6N BAJA, Media Y Alta Ganancia GainConmutador DE Refuerzo Boost Diodo DEL Canal LIMP10 CleanDiodo DEL Canal Primario Lead Selector DE Canales Channel SelectorDiodo Activo Volumen Principal MasterSalidas Para Altavoces Speaker Outputs Enchufe DEL Pedal DE Control RemotoNiveles Caracteristiques Bright Switch Sklecteur de brillanceHigh Gain Input Entrk haut gain LOW Gain Input Entr6 faible GainCommande DE Resonance DEL CleanCommande DE Presence Commutateur D’AUGMENTATIONFiche DE Pedale DE Commande a Distance Volume CentralSignal DEL Actif Niveau Impedance Selector Switch Selecteur d’impbdanceEffects Return Retour d’effets Preamp OUT Sortie prkampliTIEF-, MITTEL- UND HOCHTON-EQUALIZER LEISTUNGSVERSTiiRKUNGKanalauswahl BOOST-SCHALTERReverb to Main TREMOLO-GESCHWINDIGKEITPrasenzfilter Power LEDHauptlautstarkeregler AKTIV-LEDLAUTSPRECHERAUSGiiNGE Impedanz WahlschalterPage Peavey ONE-YEAR Limited WARRANTY/REMEDY Or less Important Safety Instructions#80302