POWER AMPLIFIER SECTION
The following specs are measured
@1 kHz with presence and resonance at 0 and effects level at 10.
Lead Channel:
(Channel Select In)
Nominal Input Level:
Minimum Input Level:
Rated Power & Load:
120 W RMS into 16, 8, or 4 ohms
Power @ Clipping:
Typically @ 5% THD, 1 kHz, 120 V AC line 120 W RMS into 16, 8, or 4 ohms
Frequency Response:
+O,
Hum & Noise:
Greater than 85 dB below rated power
Power Amp EQ:
Active presence: +10 dB @ 2 kHz
Active resonance: +lO dB @ cabinet resonant frequency
Power Consumption: (Domestic)
400 watts, 50/60 Hz, 120 V AC
PREAMP SECTION
The following specs are measured @ 1 kHz with the controls preset as follows:
Low & High EQ @ 10 MidEQ @ 0
Bright Out
Boost Out
Shift Out
Lead Posts @ 10
Presence & Resonance @ 0 Master Level @ 10 Effects Level @ 10 Reverb @ 0 Tremolo/Speed & Intensity @ 0 Nominal levels with pre gains @ 5 Minimum levels with pre gains @ 10
Preamp High Gain Input:
Clean Channel:
(Channel Select Out)
Nominal Input Level:
Minimum Input Level:
Maximum Input Level: 0 dBV, 1 .O V RMS
Preamp Low Gain Input:
Impedance: High Z, 44
All levels are increased by +6 dB
Effects Send:
Load Impedance: 47
Output Level:
Effects Return:
Impedance Very high Z, 470
Input Level:
Preamp Output:
Load Impedance: 47
Nominal Output: +lO dBV, 3 V RMS
Remote Footswitch:
Special 4 button unit with LED indicators, Channel Select, Effects Loop Bypass, Reverb & Tremolo Bypass
System Hum & Noise @ Nominal Level: (Clean Channel)
20 Hz to 20 kHz unweighted
Greater than 75 dB below rated power
Equalization:
Custom Low, Mid & High passive type EQ Push Bright +6 dB @ 2 kHz
Push Boost increases Gain in midrange
Push Shift (Lead Channel Only) shifts frequency of mid
Impedance: Very high Z, 470