Bogen CAM8PRO manual Fine Tuning, Phantom Power

Page 16

Fine Tuning

Low Cut Switch

To remove excessive bass from an individual channel, press the Low Cut Switch (1) for that channel.

+			+
-			-
M.A	1	Low	M.A
BUS	1	Cut	BUS

1

This feature helps eliminate low frequency noise (signals of 150 Hz and below, such as back- ground rumble from ventilation systems, etc.) and is used primarily with mic-level input. It is particularly effective when handheld mics are used.

Phantom Power

If a condenser microphone(s) is not independently powered, press Phantom Power Switch

(2) to the “on” position.

The phantom power switch will power condenser (capacitor) mics through the mic cable.

Depressing the button simultaneously applies phantom power to all channels set to mic-level.

Page 16 of 32

Image 16

Contents CAM8-Series Maintenance & Service Important Safety InformationDomestic and International Listings Contents Introduction CAM8-Series Safety Instructions Quick Start Panel Descriptions CAM8 Front PanelCAM8PRO Front Panel LED Bar Graph Output MeterThreshold Control Ratio ControlCAM8/CAM8PRO Rear Panel Helpful Hints Installation AUX OUT Main Operation Troubleshooting Gain Structure If channel volume is too lowIf channel volume is too high If channel clipping occursRecommended Input Wiring Methods Balanced Source to Balanced Input Method 1 NormalBalanced Source to Balanced Input Method Unbalanced Source to Balanced Input MethodFine Tuning Phantom PowerCompressor/Limiter CAM8PRO only Special Features Activation Jumper Options Linking Simple Linking Complex Linking J17 Aux Out Main Out Aux Out Main Out AuxAC Power Connection Technical SupportTroubleshooting Tips Excessive Hiss or HUMGlossary Specifications Technical InformationAuxiliary Circuits Block Diagram Warranty Page Page Spring Street, Ramsey, NJ Tel -934-8500, Fax