Bogen CAM8PRO manual AC Power Connection, Technical Support

Page 23

AC Power Connection

This mixer is powered by an 18 Volt, 1.5 Amp center-tapped transformer (supplied). If anoth- er AC supply is used, it should be of equal voltage and have at least a 21 Volt-Amp rating.The details of the AC Power Jack on the rear panel are as shown in the following figure.

Center

No connect

AC AC

Technical Support

Our Applications Engineering Department is available to help you troubleshoot problems with your Bogen equipment. Engineers are available from 8:30 AM to 6:00 PM, Eastern Standard Time. Phone 1-800-999-2809.

Page 23 of 32

Image 23

Contents CAM8-Series Domestic and International Listings Important Safety InformationMaintenance & Service Contents Introduction CAM8-Series Safety Instructions Quick Start CAM8 Front Panel Panel DescriptionsRatio Control CAM8PRO Front PanelLED Bar Graph Output Meter Threshold ControlCAM8/CAM8PRO Rear Panel Helpful Hints Installation AUX OUT Main Operation If channel clipping occurs Troubleshooting Gain StructureIf channel volume is too low If channel volume is too highUnbalanced Source to Balanced Input Method Recommended Input Wiring MethodsBalanced Source to Balanced Input Method 1 Normal Balanced Source to Balanced Input MethodPhantom Power Fine TuningCompressor/Limiter CAM8PRO only Special Features Activation Jumper Options Linking Simple Linking J17 Aux Out Main Out Aux Out Main Out Aux Complex LinkingTechnical Support AC Power ConnectionExcessive Hiss or HUM Troubleshooting TipsGlossary Technical Information SpecificationsAuxiliary Circuits Block Diagram Warranty Page Page Spring Street, Ramsey, NJ Tel -934-8500, Fax