Bogen CAM8PRO manual Simple Linking

Page 21

Simple Linking

Simple linking or “daisy-chaining” allows the expansion of mixer inputs in multiples of 8 inputs by chaining together multiple mixers with auxiliary buses.To preserve certain mixer features, this must be done in the way shown below. Follow these steps (see page 18 for jumper loca- tions):

1. For each mixer, remove the jumper from J2 and place it on J1.This causes the Auxiliary Out level to be set by an internal pot, fixing the linked gain structure. The external pot only controls the headphone out level.

2.In the last mixer in the chain, remove the jumper from J18. Leave the jumper in place on J17.This routes the AUX In to the Main output, preserving the Compressor/Limiter feature.

3.All other mixers in the chain should have jumper J18 in place, and J17 removed.

4.Connect each mixer’s AUX Out terminals with the AUX In terminals of the next mixer in the chain.

5.Take the summed daisy-chain output from the Main Out terminals of the last mixer in the daisy-chain.This must be the mixer with J17 in place (from step 2).

6.All mixers except the last mixer in the chain (#1 in the drawing below) must have all its front panel M-A switches in the A position, to route its inputs to the auxiliary bus.The posi- tion of jumpers J17 and J18 in the first mixer (#4 in the drawing below) do not matter, and can be left undisturbed.

You should now have a daisy-chain configured as shown in the drawing below. Note that the position of J17 and J18 are shown within the drawing of each mixer in the chain (except mixer #4 in which the jumper position is immaterial).

Mixer 1

J17

 

 

 

 

 

 

Aux Out Main Out

Aux

 

In

 

 

 

 

 

 

 

 

 

 

 

 

 

Mixer 2

J18

Aux Out Main Out Aux In

Mixer 3

J18

 

 

 

 

 

Aux Out Main Out

Aux

 

In

 

Mixer 4

Aux Out Main Out

Aux In

 

 

Page 21 of 32

Page 20 Page 22
Image 21
Page 20 Page 22
Contents CAM8-Series Important Safety Information Maintenance & ServiceDomestic and International Listings Contents Introduction CAM8-Series Safety Instructions Quick Start CAM8 Front Panel Panel DescriptionsLED Bar Graph Output Meter CAM8PRO Front PanelThreshold Control Ratio ControlCAM8/CAM8PRO Rear Panel Helpful Hints Installation AUX OUT Main Operation If channel volume is too low Troubleshooting Gain StructureIf channel volume is too high If channel clipping occursBalanced Source to Balanced Input Method 1 Normal Recommended Input Wiring MethodsBalanced Source to Balanced Input Method Unbalanced Source to Balanced Input MethodPhantom Power Fine TuningCompressor/Limiter CAM8PRO only Special Features Activation Jumper Options Linking Simple Linking J17 Aux Out Main Out Aux Out Main Out Aux Complex LinkingTechnical Support AC Power ConnectionExcessive Hiss or HUM Troubleshooting TipsGlossary Technical Information SpecificationsAuxiliary Circuits Block Diagram Warranty Page Page Spring Street, Ramsey, NJ Tel -934-8500, Fax
Top Page Image Contents