Bogen CAM8PRO manual Warranty

Page 29

Warranty

The CAM8 and CAM8PRO are warranted to be free from defects in material or workmanship for two (2) years from the date of sale to the original purchaser.Any part of the product covered by this warranty that, with normal installation and use, becomes defective will be repaired or replaced by Bogen, at our option, provided the product is shipped insured and prepaid to: Bogen Factory Service Department, 50 Spring Street, Ramsey, NJ 07446, USA.The product will be returned to you freight prepaid.This warranty does not extend to any of our products that have been subjected to abuse, misuse, improper storage, neglect, accident, improper installation or have been modified or repaired or altered in any manner whatsoever, or where the serial number or date code has been removed or defaced.

THE FOREGOING LIMITED WARRANTY IS BOGEN'S SOLE AND EXCLUSIVE WARRANTY AND THE PUR- CHASER'S SOLE AND EXCLUSIVE REMEDY. BOGEN MAKES NO OTHER WARRANTIES OF ANY KIND, EITHER EXPRESS OR IMPLIED, AND ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY DISCLAIMED AND EXCLUDED TO THE MAXIMUM EXTENT ALLOWABLE BY LAW. Bogen's liability arising out of the manufacture, sale or supplying of products or their use or dispo- sition, whether based upon warranty, contract, tort or otherwise, shall be limited to the price of the product. In no event shall Bogen be liable for special, incidental or consequential damages (including, but not limited to, loss of profits, loss of data or loss of use damages) arising out of the manufacture, sale or supplying of products, even if Bogen has been advised of the possibility of such damages or losses. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Products that are out of warranty will also be repaired by the Bogen Factory Service Department — same address as above or call 201-934-8500. The parts and labor involved in these repairs are warranted for 90 days when repaired by the Bogen Factory Service Department. All shipping charges in addition to parts and labor charges will be at the owner's expense.All returns require a Return Authorization number.

8/2004

Page 29 of 32

Page 28 Page 30
Image 29
Page 28 Page 30
Contents CAM8-Series Domestic and International Listings Important Safety InformationMaintenance & Service Contents Introduction CAM8-Series Safety Instructions Quick Start CAM8 Front Panel Panel DescriptionsLED Bar Graph Output Meter CAM8PRO Front PanelThreshold Control Ratio ControlCAM8/CAM8PRO Rear Panel Helpful Hints Installation AUX OUT Main Operation If channel volume is too low Troubleshooting Gain StructureIf channel volume is too high If channel clipping occursBalanced Source to Balanced Input Method 1 Normal Recommended Input Wiring MethodsBalanced Source to Balanced Input Method Unbalanced Source to Balanced Input MethodPhantom Power Fine TuningCompressor/Limiter CAM8PRO only Special Features Activation Jumper Options Linking Simple Linking J17 Aux Out Main Out Aux Out Main Out Aux Complex LinkingTechnical Support AC Power ConnectionExcessive Hiss or HUM Troubleshooting TipsGlossary Technical Information SpecificationsAuxiliary Circuits Block Diagram Warranty Page Page Spring Street, Ramsey, NJ Tel -934-8500, Fax
Top Page Image Contents