Quick Start
1. | Unpack and Connect (See page 11 for more details). |
| A. Check mixer for shipping damage. |
Rack Mounting: To mount the CAM8 and CAM8PRO to a 19” rack, lift the unit up to the front of the rack and secure it to the front of the rack with the necessary screws (not included with this unit).
B. If special features (see page 18) are to be used, they must be programmed before mixer is mounted.
C.Turn off both mixer and amplifier and turn all volume controls to zero.
D. Connect inputs and set the input pad switch for each channel at the appropriate level (either MIC or line). Make sure that the bus selector is set for Main Out.
E. Connect output(s) and set the main output pad switch at the appropriate level (either MIC or line). (Auxiliary output is
2.Power and Set Up (See pages
A.Connect mixer AC power supply.
B.Turn volume controls down, then power up mixer and amplifier.
Note: Mixer will produce signal transients on power up and power down. Always turn the mixer on first before turning on the amplifier and always turn the amplifier off first before turning off the mixer.
C. Adjust Main/AUX out controls to the 2 o’clock position. Then turn amp up to normal level while performing audio test.
D. Adjust input gain/trim control for each channel to get a meter reading within the green area.
E. Adjust individual channel volume controls to the 2 o’clock position.
3.Fine Tuning (See page 16 for details).
A.In the event of excessive bass, press Low Cut filter switch(es) “on.”
B.If condenser mics are used, press phantom power switch “on” (turns phantom power on for all inputs set to MIC position).
C.(CAM8PRO only) In the event of occasional excessive output level, press Compressor/Limiter switch “on”.
Page 6 of 32