Bogen CAM8PRO manual Complex Linking, J17 Aux Out Main Out Aux Out Main Out Aux

Page 22

Complex Linking

Complex Linking allows multiple mixers to produce two separate mixes from the same set of inputs.The most common complex linking application is shown below.This method can also be used to implement a “mix minus” application.

This method (CAM8PRO only) creates two separate mixes. Both destinations are routed through the Compressor/Limiter, since both destinations are driven by Main outputs. Destination 1 receives inputs from Mixer 1 with Main/Auxiliary bus selector set to Main, and inputs from Mixer 2 with Main/Auxiliary bus selector set to AUX. Destination 2 receives inputs from Mixer 1 with Main/AUX set to AUX, and inputs from Mixer 2 with Main/AUX set to Main.

To create this complex mix, take the following steps:

1. Following the directions on page 19, set jumpers as shown in the drawing below: J17 alone in both mixers.

2.For both mixers, remove jumper from position J2 and place it in position J1.This gives internal control of both auxiliary buses.

3.Connect the two mixers as shown in the drawing below.

Mixer 1

J17

Mixer 2

J17

 

 

 

 

 

Aux Out Main Out

Aux

 

In

 

Aux Out Main Out Aux In

1

2

Destination 1 receives inputs from mixer 2 with the M-A switch set to auxiliary, and from mixer 1 with the M-A switch set to main.

Destination 2 receives inputs from mixer 2 with the M-A switch set to main, and from mixer 1 with the M-A switch set to auxiliary.

Page 22 of 32

Page 21 Page 23
Image 22
Page 21 Page 23
Contents CAM8-Series Maintenance & Service Important Safety InformationDomestic and International Listings Contents Introduction CAM8-Series Safety Instructions Quick Start Panel Descriptions CAM8 Front PanelThreshold Control CAM8PRO Front PanelLED Bar Graph Output Meter Ratio ControlCAM8/CAM8PRO Rear Panel Helpful Hints Installation AUX OUT Main Operation If channel volume is too high Troubleshooting Gain StructureIf channel volume is too low If channel clipping occursBalanced Source to Balanced Input Method Recommended Input Wiring MethodsBalanced Source to Balanced Input Method 1 Normal Unbalanced Source to Balanced Input MethodFine Tuning Phantom PowerCompressor/Limiter CAM8PRO only Special Features Activation Jumper Options Linking Simple Linking Complex Linking J17 Aux Out Main Out Aux Out Main Out AuxAC Power Connection Technical SupportTroubleshooting Tips Excessive Hiss or HUMGlossary Specifications Technical InformationAuxiliary Circuits Block Diagram Warranty Page Page Spring Street, Ramsey, NJ Tel -934-8500, Fax
Top Page Image Contents