Teledyne IGE 3000 instruction manual Non-Warranty Repair Policy

Page 20

9. WARRANTY

9.1.Warranty Repair Policy

Hastings Instruments warrants this product for a period of one year from the date of shipment to be free from defects in material and workmanship. This warranty does not apply to defects or failures resulting from unauthorized modification, misuse or mishandling of the product. This warranty does not apply to batteries or other expendable parts, or to damage caused by leaking batteries or any similar occurrence. This warranty does not apply to any instrument which has had a tamper seal removed or broken.

This warranty is in lieu of all other warranties, expressed or implied, including any implied warranty as to fitness for a particular use. Hastings Instruments shall not be liable for any indirect or consequential damages.

Hastings Instruments, will, at its option, repair, replace or refund the selling price of the product if Hastings Instruments determines, in good faith, that it is defective in materials or workmanship during the warranty period. Defective instruments should be returned to Hastings Instruments, shipment prepaid, together with a written statement of the problem and a Return Material Authorization (RMA) number.

Please consult the factory for your RMA number before returning any product for repair. Collect freight will not be accepted.

9.2.Non-Warranty Repair Policy

Any product returned for a non-warranty repair must be accompanied by a purchase order, RMA form and a written description of the problem with the instrument. If the repair cost is higher, you will be contacted for authorization before we proceed with any repairs. If you then choose not to have the product repaired, a minimum will be charged to cover the processing and inspection. Please consult the factory for your RMA number before returning any product repair.

TELEDYNE HASTINGS INSTRUMENTS 804 NEWCOMBE AVENUE HAMPTON, VIRGINIA 23669 U.S.A.

ATTENTION: REPAIR DEPARTMENT

TELEPHONE

(757) 723-6531

TOLL FREE

1-800-950-2468

FAX

(757) 723-3925

E MAIL

hastings_instruments@teledyne.com

INTERNET ADDRESS

http://www.teledyne-hi.com

Repair Forms may be obtained from the “Information Request” section of the Hastings Instruments web

site.

IGE 300

Page 20 of 21

Image 20
Contents Teledyne Hastings Manual Print History Table of Contents IGE Quick Start Information To Turn on the TUBE’S FilamentsSpecifications General InformationGeneral Information IGE-3000 Mini Bayard/Alpert B/A TubeMaterials exposed to Vacuum Installation InstallationReceiving Inspection MountingConnector Electrical Pin outs B/A Tube InstallationMounting B/A tube to IGE-3000 Electronics Module EnvironmentalApply Power OperationOperation Front Panel OverviewOperating Modes DGas Mode Factor ModeFil filament Mode SP set point ModeRemote Filament Control Theory of Operation Bayard Alpert B/A TubeSet Up Guide Advance Setup GuideRS485 Address Baud RateTurnaround Delay Restore EepromData Bits/Parity Bits/Stop Bits Save EepromRS232/RS485 Wiring for IGE-3000 RS232/485 Wiring for RS232/485RS 232/RS ION Gauge Device Status 4-DIGIT Octal Word Command SyntaxDevice Status Command Description Format Sample Response Interrogation CommandsParameter Modification Commands Warranty Repair Policy Non-Warranty Repair PolicyDrawings & Schematics
Related manuals
Manual 21 pages 27.57 Kb