Teledyne IGE 3000 instruction manual Drawings & Schematics

Page 21

10.Drawings & Schematics

High Low

F1

F2

Emis DGas SP K Fil

2X=On/Off

HASTINGS

IGE 300

Page 21 of 21

Image 21

Contents Teledyne Hastings Manual Print History Table of Contents IGE To Turn on the TUBE’S Filaments Quick Start InformationGeneral Information SpecificationsGeneral Information IGE-3000 Mini Bayard/Alpert B/A TubeMaterials exposed to Vacuum Installation InstallationReceiving Inspection MountingB/A Tube Installation Connector Electrical Pin outsMounting B/A tube to IGE-3000 Electronics Module EnvironmentalOperation Apply PowerOperation Front Panel OverviewOperating Modes Factor Mode DGas ModeFil filament Mode SP set point ModeRemote Filament Control Bayard Alpert B/A Tube Theory of OperationAdvance Setup Guide Set Up GuideRS485 Address Baud RateRestore Eeprom Turnaround DelayData Bits/Parity Bits/Stop Bits Save EepromWiring for IGE-3000 RS232/485 Wiring for RS232/485 RS 232/RSRS232/RS485 Command Syntax Device StatusION Gauge Device Status 4-DIGIT Octal Word Interrogation Commands Parameter Modification CommandsCommand Description Format Sample Response Non-Warranty Repair Policy Warranty Repair PolicyDrawings & Schematics

Related manuals

Manual 21 pages 27.57 Kb