Teledyne IGE 3000 RS 232/RS, RS232/RS485, Wiring for IGE-3000 RS232/485 Wiring for RS232/485

7. RS 232/RS 485

7.1.RS232/RS485

The IGE-3000 is designed to communicate with external devices by either RS232 or RS485 via the two RJ-11 connectors. Refer to section 3.2 Figure 2 for connector locations. RS232 via the left connector on and the RS485 is via either connector. Software capable of communicating with the IGE-3000 is available upon request.

Refer to Figure 7 below for pin out and wiring information.

7.1.1.Wiring for IGE-3000 RS232/485

7.1.2.Wiring for RS232/485

	RS 485 half duplex			RS 485 full duplex
Pin #1		T+/R+	Pin #1		T+
Pin #2		T-/R-	Pin #2		T-
Pin #3		GND	Pin #3		GND
Pin #4		GND	Pin #4		GND
Pin #5		n/a	Pin #5		R-
Pin #6		n/a	Pin #6		R+

IGE 300 Page 17 of 21