Enviro C-10100 service manual Flame Lifting, Vented Models, Do not GO TOO FAR or Unit will Soot

Page 19

6)FLAME LIFTING

A)B-VENTED MODELS

Check air shutter on the

burner tube (venturi).

Make sure there are no

leaks in the venting system.

Improper venting

configuration.

Make sure that manifold

(outlet).

Pressure is correct.

Adjust air shutter, by

closing shutter.

DO NOT GO TOO FAR OR

THE UNIT WILL SOOT.

Seal venting if necessary.

Correct if necessary.

Use a manometer to check

gas pressure.

SEE PAGE 5 FIGURE 7.


	Sherwood Industries Ltd.	ENVIRO	PAGE 17

Image 19

Contents GAS Fireplace Suggested Tools List for Servicing Table of ContentsSee page 2 Figure 1PILOT will not Light No Spark Ignition System175mm See page 4 Figure Piezo Ignitor OK but Pilot will Still not LightTo remove pilot injector Exploded View S.I.T Pilot AssemblySupply Pressures 50% Turn Down Natural GAS Propane GAS Thermocouple for These Readings should be Constant with no FluctuationProper Voltage CheckingPilot will not Stay LIT T Eurosit Modulating 630 Series See page 8 Figure Main Burners will not LightSee page 6 Figure Main Burners will not Light CON’T Vented Models Main Burners will not Stay LITSee Enviro Sample Direct Vent Chimney Installations ALL Models Enviro Sooting Enviro See page 5 Figure Enviro Flame LiftingVented Models Do not GO TOO FAR or Unit will SootDirect Vent Models Blower Diagnosis ALL Models Natural GAS Propane GAS DRILL# Size Orifice Sizing ChartStep by Step Service Instructions Cleaning the Appliance Glossary