Hampton Direct U32-LP2, U32-NG2 Faceplate & Trim Installation, Rear View Trim Assembly Diagram

INSTALLATION

		A)02-43
45	F)02-48
B)02-
	Side View
	Bracket	Front edge of
		rear burner

The bottom right edge of Log F)02-48 must sit snugly against the bracket and the front edge of the rear burner.

9)Place Front Left Log G)02-44 onto the 2 front pins as shown.

G)02-44

10) Place the embers and Rockwool on the exposed front burner tray.

FACEPLATE & TRIM

INSTALLATION

1)Lay the faceplate panels flat, face down on something soft so they don't scratch.

2)Take the top faceplate and align the holes in it with the holes in the side panels. Using the screws provided, attach from the top of the panel (the holes in the top panel are slightly larger than the holes in the side panel to facilitate easier installation). Dia- gram 1.

Rear View: Trim Assembly

Diagram 2

5)Connect the fan switch wires by taking the black and red wires with the male ends (in the grey harness) and connect them with the wire connectors from the fan speed control.

6)Connect the ON/OFF switch wires by tak- ing the black and red wires with the female ends and connect them to the ON/OFF switch.

7)Tuck the wires into the faceplate to keep them away from the insert using the clip provided. Attach the clip to the rear of the faceplate to ensure that the wires do not touch the side of the unit. Diagram 3.

Rear View: Faceplate Assembly

Diagram 1

11)Test fire to ensure proper light off (make sure flame flows smoothly from one end of burner to the other. If there is any flame hesitation, check that area for any block- age of the burner port.

12)Install flush glass and optional bay glass as per instructions in this manual.

			F)02		A)02-43
			-
				48
-46		47
		-
D)02	C)02-56	E)02			B)02-45
G)02-44

Hint: Don't tighten the screws down com- pletely at this point, continue on with steps 3 and 4 and do a trial fit to the unit. Make any necessary adjustments and when it fits properly then tighten down the screws.

Hearth Trim Option: Hearth Trim is an option that can be used to finish off the installation when the bottom of the fireplace is higher than the hearth or to raise the fireplace. Attach the Hearth Trim to the bottom of the faceplate side panels with the screws provided. See Diagram 1.

3)Using the connectors provided, join the left side trim (with the ON/OFF switch) to the top trim. Diagram 2. Connect the right side trim to the top trim.

4)Place the trim on the assembled faceplate panels, aligning the wire connections from the switches with the notch on the left side panel.

Diagram 3

8)The power cord should be run behind the faceplate panel.

9)Attach the brass trim to the faceplate by drilling a 1/8" hole through into the faceplate using the hole in the trim as a guide. Fasten the trim to the faceplate panels using the plated screws. Diagram 4.

10)Attach the faceplate panels to the insert body using the 4 remaining black screws. Diagram 5.

10 U32-2 FPI Direct Vent Gas Insert