INSTALLATION
Diagram 2
Use the hook to pull the spring out until you can
put the hook into the slot on the bottom door bracket. Repeat for 2nd spring.
See diagram 3.
Diagram 4
OPTIONAL DOUBLE DOOR FIRE SCREEN
1)Pull out the top louver.
2)Center the screen door and hook over
the flush door.
Diagram 5
11)Push the Regency logo plate into the two holes in the bottom left corner of the face- plate.
STANDARD
FLUSH DOOR
Diagram 3
To remove the flush door, reverse the above steps.
NOTE: The chain must rest on TOP of the gas inlet pipe never under it.
3)Open the screen door(s) and secure the screen door to the flush door front with 2 clips on the bottom left and right side.
Clip locations
The standard flush door comes with a black frame. To install the frame, simply hook the top door flange onto the top of the unit and swing the door towards the unit, diagram 1. Be careful that the glass gasket does not roll up; there must be a gap between the gasket and the door lip to ensure that the door sits securely on the unit. Diagram 2.
Diagram 1a
Diagram 1b
OPTIONAL |
| Clip installed | |
on right side. | |||
|
| ||
FLUSH TRIM |
| ||
FLUSH LOUVERS | |||
|
| ||
Attach 2 round magnets to the back of the top | 1) The top louver is held in place by friction fit, | ||
trim piece and the other 2 to the bottom trim | if the louver needs to be adjusted; bend the | ||
piece, then attach trim to the top and bottom of | bracket out as shown in the diagram. | ||
Flush door. |
| ||
Note: Top and bottom louvers are different.
2) The bottom louver has a hinge that is at- tached (2 screws per hinge) to the lip on bottom of the unit.
11 |