LOG SET Installation | Hampton Direct U32-NG2, U32-LP2 guide

INSTALLATION

LOG SET

INSTALLATION

3) Place Rear Log A)02-43 on the two pins on	6) Place the Left Top Log D)02-46 on the pin on
the rear log support.	Log C)02-56 and on top of the cutout on Log
	A)02-43.

Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

The gas log kit contains the following:

a)	02-43	Rear Log	902-227
b)	02-45	Front Right Log	902-229
c)	02-56	Middle Left Log	902-230
d)	02-46	Left Top Log	902-231
e )	02-47	Center Log	902-232
f)	02-48	Middle Right Log	902-226
g)	02-44	Front Left Log	902-228
h)		Embers	902-154
i)		Rockwool	902-153
j)		Vermiculite	902-179/21

A)02-43

Pins on Rear Log Support

4)Place Front Right Log B)02-45 on the two pins as shown.

D)02-46

A)02-43

C)02-56

PinCutout

7)Place the notch in Center Log E)02-47 over Log B)02-45 and across the cutout on Log A)02-43.

Note: Install Optional Brick Panels prior to installing logs.

B)02-45	E)02-47	A)02-43
		A)02-43

B)02-45

5)Place the Middle Left Log C)02-56 on the two pins as shown.

Notch Cutout

The "02" refer numbers (i.e. 02-43) are

molded into the rear of each log.

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Sprinkle the vermiculite around the firebox base. Take some of the embers (approx. 1/3 of the bag) and sprinkle over the ver- miculite.

Vermiculite and	Vermiculite	and	Vermiculite and
embers.			embers.
	embers.

C)02-56

Logs D)02-46 and E)02-47 in position.

8)Position notch in Front Right Log F)02-48 on Log E)02-47 and push the bottom right edge against the bracket on the burner tray and the front edge of the rear burner.

F)02-48

Logs A)02-43, C)02-56, and B)02-45 in position

B)02-45

Notch

Bracket

U32-2 FPI Direct Vent Gas Insert