OWNER'S MANUAL
INSTALLATION
Continued
THERMOSTAT SENSING BULB
The thermostat sensing bulb has been placed inside the heater for protection during shipping.
Locating Thermostat Sensing Bulb
INSTALLATION OPTIONS
There are three options for mounting this heater.
A.Mounting heater to wall
B.Mounting heater to optional hearth base
C.Mounting heater with optional hearth base to optional mantel.
A. MOUNTING HEATER TO WALL
Marking Screw Locations
1.Tape mounting bracket to wall where heater will be located. Make sure
mounting bracket is level.
clearances shown in Figure 13. If
you can, provide greater clear-
,_kWARNING: Maintain minimum I ances from floor and joining wall.
1.Remove front panel of heater (see Fig- ure 2. page 4).
2.Locate thermostat sensing bulb just under burner assembly.
IMPORTANT: Attach thermostat sensing bulb to back of heater for proper operation.
| 2. Mark screw locations on wall (see Fig- | |
Mounting Bracket | ure 13). | |
The mounting bracket is located on back | Note: Only mark last hole on each end | |
of mounting bracket. Insert mounting | ||
panel of heater. It has been taped there for | ||
screws through these holes only. | ||
shipping. Remove mounting bracket from | ||
| ||
back panel. | 3. Remove tape and mounting bracket | |
| from wall. |
Attaching Thermostat Sensing Bulb
1.Remove thermostat sensing bulb from holders inside heater. Route through slot opening in bottom of heater.
2, Place clamp on thermostat sensing bulb as shown in Figure 11. Clamp is pro- vided in hardware package.
3.Snap clamp into upper mounting hole as shown in Figure 11. Mounting hole is located on lower left edge on back of heater. Make sure the thermostat
sensing bulb is pointing up.
Thermostat
SensingBulb
Clamp
Mounting
Bracket
Figure 12 - Mounting Bracket Location
Methods | For Attaching |
|
Mounting | Bracket To Wall | Figure 13- Mounting Bracket Clearances |
Only use last hole on each end of mounting bracket to attach bracket to wall. These two
holes are 16 inches apart from their centers. Attach mounting bracket to wall in one of two ways.
1, Attaching to wall stud
2, Attaching to wall anchor
Attaching to wall stud This methodpro- vides the strongesthold. Insert mounting screwsthroughmountingbracket and into wall studs,
Attaching to wall anchor This method allows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).
Figure 11.Attaching Thermostat Sensing
BulbDecide which method better suits your needs. Either method will provide a secure hold for the mounting bracket.
Cominucd