Dacor OBS36, OBSB162, OBS52 Verifying Proper Operation, Power Connection Cabinet Installations

Page 22

Installation Instructions

2.With the tank shelf open, connect the power cord from the outdoor grill and the warming oven (if equipped with one) to the electrical outlet on the back panel inside the cart.

3.Connect the rotisserie motor power cord to the electri- cal outlet on the back side of the cart.

Electrical Outlet with Ground Fault Interrupter

Power Connection - Cabinet Installations

Connect the appliance(s) to an electrical outlet that meets the specifications in the Planning the Installation section.

The rotisserie motor should be plugged into the same outlet or an alternate 120 Vac outlet on the same circuit as the appliance.

Verifying Proper Operation

Lighting Instructions

1.Read and understand the accompanying use and care manual prior to cooking with this appliance. The use and care manual contains additional important safety, service and warranty information.

2.No adjustment of burner settings is required. All valves and air mixture shutters found in this appliance have been factory preset.

3.With the gas shut-off valve open, turn all

burner knobs to the HIGH position for

 

approximately 20 seconds to allow the air

 

in the system to purge from the grill and

HIGH

cooktop side burners.

4.Once the gas has filled the lines the auto- matic electronic ignition system should ignite the burner. If the system burners

do not ignite within 20 seconds turn all

burner controls to the OFF position. Wait OFF five minutes and attempt the ignition pro-

cess again.

5.Visually check the burner flame for proper operation. Proper flame operation will show a steady, soft blue color and stable flame.

6.If the second or third attempt to ignite the burner is not successful then turn all burner controls to the OFF position.

7.If the grill or cooktop fails to operate properly, make sure that power to the electrical outlet and gas supply are turned on and that all installation steps have been carefully followed. Check also for a tripped ground fault interrupter on the electrical outlet. Push in on the RESET button.

NOTE: If using an extension cord, the igniters will not spark properly if the cord is not supplying a solid ground.

If the grill still will not light, close the gas shut-off valve. Do not attempt to repair the appliance yourself. Contact Dacor Distinctive Service at (877) 337-3226. Have the model and serial number from the product data label available when you call.

Dacor is not responsible for the cost of correcting problems caused by a faulty installation.

Installation Checklist

warning

To ensure a safe and proper installation, the follow- ing checklist should be completed by the installer to ensure that no part of the installation has been over- looked.

Proper installation is the responsibility of the hom- eowner. The importance of proper installation of your Dacor Outdoor Grill cannot be over emphasized.

□□ Is the electrical outlet for the appliance grounded and located according to these instructions and in accor- dance with all applicable electrical codes for outdoor appliances?.

□□ Is the gas service for the appliance located and installed according to these instructions and in accor- dance with all applicable codes?

□□ Has the gas supply inlet pressure been measured to ensure that it does not exceed the maximums and meets the minimum stated in these instructions?

□□ Is the appliance secured to the cabinet or cart?

□□ Are the grease tray, flame spreaders, grates and, if applicable, burner heads and caps properly installed according to these instructions?

□□ Has proper operation been verified? Did the installer check the gas supply for leaks?

□□ Have any problems been noted on the warranty card or during the on-line warranty activation? Has the war- ranty been activated on-line or the warranty card filled out completely and mailed?

17

Image 22
Contents OB36, OB52, OBS36, OBS52, OBSB162 13.2 13.3 Installation Instructions Epicure Outdoor Grill Table of Contents Important Information About Safety Instructions Safety Symbols and LabelsGeneral Safety Precautions Important Safety Instructions OB36 Product DimensionsOB52 Overall Number Width HeightLocation Planning General Gas and Electric Power RequirementsElectrical Requirements OBSB162 Cutout Dimensions Side View Enclosed Cabinet Installations with a LP CylinderOB36, OBS36, OB52 and OBS52 Cutout Dimensions Side View Location Planning Enclosed CabinetsCutout Dimensions Top View OBSB162Location Planning Cart Installations Example of Grill Cart LocationModels OB36, OBS36, OB52 and OBS52 Preparing for InstallationParts List Models OB52, OBS52 and OBSB162Installation Instructions OB36 or Cabinet InstallationCart Installation OB52 orOptional Side Shelf Installation Gas Connection LP Gas Cylinder Hose Connecting the GasGas Connection Natural Gas Gas Connection Whole House LP GasAssemble the Grill Final Assembly and TestAssemble the Side Burner Some Models Leak Testing LP Cylinder Installation Some ModelsPower Connection Cart Models Verifying Proper Operation Power Connection Cabinet InstallationsInstallation Checklist Lighting InstructionsWiring Diagrams Wiring Diagram OBS52 Page Page Page Ta b l e o f C o n t e n t s Back CoverDacor. all rights reserved Important Safety Instructions Model Number Serial NumberUse an adapter plug Important Safety Instructions Optional Grill Cart Features Outdoor Grill FeaturesGetting to Know Your Outdoor Grill Models OB36 and OBS36 Grill compartmentGrill compartment Locking wheels Setting Up Your Outdoor Grill Assembling the CooktopOutdoor Grill Assembly Model OBS52 shown Side burner cover Side burner grate Drip tray Warming rackLP Tank Connection Operating Your Outdoor GrillTo Connect the LP Tank Important Operating Information Selecting and Using Cookware for the Optional Side BurnerTank-less Gas Supply After CookingNever use the outdoor grill in windy conditions Lighting the BurnersLighting and Preheating Grill Compartment Light one burner at a time. Push in onBurner Lighting Notes Lighting the Side Burners OB52, OBS52 and OBSB162 OnlyBurner Knob Locations Model OBS52 Shown To manually light the optional sear burner Manual Lighting Procedures Grill CompartmentTo manually light the standard U shaped burners To manually light one of the optional sear burnersPreparing to Use the Rotisserie Rotisserie CookingThings to Know About the Rotisserie Rotisserie OperationManual Lighting Procedure Rotisserie Rotisserie burner Electrode LocationSmoker Wood Chip Types Using the Smoker BoxSmoker Cooking Adding more wood chipsTo cook using the sear burner Using the Optional Sear BurnerSafe Cooking Temperature Chart Models OBS36 and OBS52 OnlyCleaning the Grill Compartment Care and CleaningCleaning Instructions Grates Flame spreadersCleaning the Smoker Box Cleaning the Porcelain Grates and Warming RackCleaning the Rotisserie Burner and Optional Sear Burner Cleaning the Rotisserie PartsKnobs and Trim Rings Cleaning the Optional Side BurnersCleaning the Exterior Rubbing alcohol to help dissolve grimeBack of Lens Light Bulb ReplacementLight Fixture Locations Standard U Burner Removal and Replacement Parts and Accessories Before You Call for Service Problem Solution GuideWhat Is Covered Warranty and ServiceWarranty What Is Not CoveredBusiness Reply Mail Warranty Information
Related manuals
Manual 12 pages 21.22 Kb