Country Home Products Garden Cart operating instructions Attach the Upper Handle

5. Attach the Upper Handle

Attach the upper handle onto the lower handles on the bucket assembly.

•Slide the upper handle through the handle holes in the upper bucket, and then over the lower handle tubes on the bucket assembly. Make sure the screw holes align.

•Tilt the Cart up on its nose. This makes it easier to screw the handles together.

•Open the red hardware bag which includes only two screws. Insert a 1/4" x 1-1/2" screw from the outside of the handle, passing through the screw hole where the upper and lower handles attach (Figure 5).

Screw

Washer

Lock Nut

Insert here

Figure 5. Screw the upper handle onto the lower handles.

•Once the screw is completely through the handle

assembly, place a 1/4" flat washer and then a 1/4" nylon lock nut on the inserted screw.

•Hold the screw with your Phillips screwdriver and tighten the nylon lock nut with a 7/16" open-end wrench.

•Now attach the other side of the handle the same way.

•Lower the Cart back onto its wheels.

6. Attach the Controls Caddy

•	The Power Pad on the controls caddy operates the	Power pad
	Cart.
• Open the red hardware bag with four screws. Place the
	four 1/4" x 1-3/4" screws in the cup holder of the controls
	caddy for easy access. Set the four small washers and
	the nylon lock nuts in a handy spot where you can easily
	reach them.	Screw and
•	Position the Controls Caddy on the upper handle, align	Washer
		Washer
	the holes on the caddy with the holes in the handle
	(Figure 6), and hold the caddy firmly against the handle.	Lock nut
•	Take the 1/4" x 1-3/4" screws from the cup holder and,	Figure 6. Securely attach the controls caddy to the
		upper handle.
	one by one, insert them into the holes. Make sure the

screws go all the way through the caddy and out the back of the handle. Slide a 1/4" small washer onto the screws, and then loosely screw a 1/4" nylon lock nut onto the screws.

Tip: If you are having trouble attaching the small washers and nylon lock nuts, you might find it easier with the Cart tilted forward on its nose.

•Hold the screw with your Phillips screwdriver and securely tighten the nylon lock nuts with a 7/16" open- end wrench.

Tip: Be sure not to attach the controls caddy over the foam handle. If need be, push up the foam a bit to fit the controls caddy flush against the metal handle.

CALL TOLL FREE 1-866-NEUTON1 15