Napoleon Grills PRO 500 manual Lighting Instructions

8

Lighting Instructions

Side

Burner

Lights

Igniter	Left	Left Centre	Right Centre		Rear	Right
	Burner	Burner	Burner	Burner		Burner

WARNING! Open lid Off Position

WARNING! Ensure all burner controls are in the off position. Slowly turn on the gas supply valve.

Main Burner	Rear Burner Lighting	Side Burner Lighting
Lighting	(if equipped)	(optional)
1. Open grill lid	1. Open grill lid	1. Open burner cover.
2. Push and turn any main burner knob	2. Remove warming rack.	2. Turn side burner control to high
slowly to the high position. If the pilot		position.
lights, continue to push down on the
control knob until the burner lights and
then release.
3. If the pilot does not ignite, then	3. Turn rear burner control to high	3. Press and hold
immediately turn the control knob back	position.	igniter button until burner lights, or
to the ‘off position and repeat step 2		light by match.
several times.
4. If the pilot and burner will not ignite	4. Press and hold	4. If ignition is not
within 5 seconds, turn the control knob	igniter button until burner lights, or	immediate, turn burner control off.
to the ‘off’ position and wait 5 minutes	light by match.	Wait 5 minutes. Repeat.
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
match.
5. If lighting the unit with a match, clip	5. If ignition is not immediate, turn
the match into the supplied lighting	burner control off. Wait 5 minutes.
rod. Hold the lit match down through	Repeat.
the grill and sear plate while turning the
corresponding burner valve to high.

WARNING! The propane cylinder is equipped with an excess flow device. Unless all burners are turned off prior to turning the cylinder on, only small flames and low heat will be achievable.

WARNING! Do not use rear burner while operating main burner.

www.napoleongrills.com