Desa VTGF33NRA installation manual Specifications, Logs

Page 22

22

CLEANING AND MAINTENANCE

Cleaning Burner Injector Holder (Cont.)

 

Logs

 

SPECIFICATIONS0

 

 

CLEANING AND

MAINTENANCE

Continued

1.Shut off the unit, including the pilot. Allow the unit to cool for at least thirty minutes.

2.Inspect burners, pilot, and primary air inlet holes on injector holder for dust and dirt (see Figures 45 and 46).

3.Blow air through the ports/slots and holes in the burners.

4.Check the injector holders located at the end of the burner tubes again. Remove any large particles of dust, dirt, lint, or pet hair with a soft cloth or vacuum cleaner nozzle.

5.Blow air into the primary air holes on the injector holders.

6.In case any large clumps of dust have now been pushed into the burner repeat steps 3 and 4.

Clean the pilot assembly also. A yellow tip on the pilot flame indicates dust and dirt in the pilot assembly. There is a small pilot air inlet hole about two inches from where the pilot flame comes out of the pilot assembly (see Figure 47). With the unit off, lightly blow air through the air inlet hole. The access hole for propane/LP pilot is on the front of the burner carriange as shown in Figure 47. The access hole for natural pilot is behind the pilot bracket on the top of burner carriage (see Figure 47). You may blow through a drinking straw if compressed air is not available.

Injector Holder

Pilot Bracket

Pilot

Assembly

Access Hole For

Cleaning PIlot

Figure 47 - Cleaning Pilot Air Inlet Hole

LOGS

Pilot Air Inlet Hole

Burner Tube

Primary Air

Inlet Holes

Figure 45 - Injector Holder On Outlet Burner Tube - Rear Burner

 

Ports/Slots

Primary Air

Injector

Inlet Holes

Holder

 

Figure 46 - Injector Holder On Outlet Burner Tubes - Front and Middle Burners

If you remove logs for cleaning, refer to Installing Logs, pages 16 and 17, to properly replace logs.

Replace log(s) if broken or chipped (dime-sized or larger).

SPECIFICATIONS

Btu (Variable)

20,000/33,000

 

Type Gas

Natural: VTGF33NRA

 

Propane/LP: VTGF33PRA

Ignition

Electronic (Automatic)/Piezo (Manual)

 

Natural Gas

Propane/LP Gas

Manifold Pressure

3.5" W.C.

8.0" W.C.

Inlet Gas Pressure (in. of water)

 

Maximum

10.5"

14"

Minimum*

5"

11"

Shipping Weight

78 lbs.

78 lbs.

* For input adjustment

 

 

For..com

110112-01A

Image 22
Contents OWNER’S Operation and Installation Manual What to do if YOU Smell GASTable of Contents Safety InformationProduct Identification Other gasesLocal Codes Product FeaturesUnpacking Unusually Tight Construction AIR for Combustion and VentilationProviding Adequate Ventilation Confined Space and Unconfined SpaceDetermining if You Have a Confined or Unconfined Space Determining FRESH-AIR Flow for Heater LocationVentilation AIR Ventilation Air From Inside BuildingCheck GAS Type InstallationVentilation Air From Outdoors Removing Fireplace Screen and Floor Assembly Installation ClearancesInstallation Sequence Electrical HookupRelocating Wall Switch Assembly Electrical Connections for Power CordRelocating Wall Switch Assembly Installing GAS Piping to Fireplace Location Mounting Wall Switch Assembly to Side of MantelConnecting Fireplace to GAS Supply Installation Items NeededPressure Testing Gas Supply Piping System Pressure Testing Fireplace Gas ConnectionsChecking GAS Connections Conventional Fireplace Installation HoleBUILT-IN Fireplace Installation Mantel Clearances for Built-In InstallationInstalling Logs Installing HoodAssembling and Attaching Optional Brass Trim Installing Battery Into Remote Installing Log #2 Right and Log #3 LeftUsing Supplied Wall Switch Assembly Installing ScreenFor Your Safety Read Before Lighting Operating FireplaceTo Turn OFF GAS To Appliance For Electrical Power OutageManual Lighting Instructions Optional Blower Operation Shutting Off Heater When Manually LitInspecting Burners Operating FANCleaning Burner Injector Holders and Pilot AIR Inlet Holes Cleaning MaintenanceBurner Flame Patterns Specifications LogsTroubleshooting Observed Problem Possible Cause RemedyFor Com Gas leak. See Warning statement Illustrated Parts Breakdown Parts List Remote Control LOG Base Assembly Models VTGF33PRA VTGF33NRAFireplace Models VTGF33NRA VTGF33PRA Fireplace Models VTGF33NRA and VTGF33PRA Accessories Laminate Trim for Hearth or Mantel Cleaning KIT GCKSlim Hearth Base Firebox Brick Liner G8000 SeriesTechnical Service Replacement PartsService Hints Wiring DiagramTemplates Diameter HolesThis page Intentionally Left Blank Owners Registration Form Postage Required 110112-01A Not a UPC