INSTALLATION
Continued
LOG PLACEMENT FOR M42, M42P, VM42 AND VM42P MODELS
1.Place large back log (log 1) onto grate making sure notches rest over grate (see Figure 29).
2.Insert lower end of log 2A between the first two grate fingers and position the upper end into the notch on the front of log 1. See Figure 29. Place log 2B on the front right side of grate as shown in Figure 29.
3.Place log 3 into notch on top left of log 1, rest- ing the lower end on the left two grate fingers (see Figure 30).
4.Place the upper end of log 4 into the notch on log 1 as shown in Figure 30. Rest the lower end of log 4 on the middle grate finger as shown in Figure 31.
Notch Log 1
Log 2A
Log 2B
Figure 29 - Installing Logs 1, 2A and 2B
Log 3 |
|
|
| Log 4 |
|
Notches | Log | 1 |
|
|
5.Place the upper end of log 5 into the notch on the top inner right of log 1 (see Figure 31). Rest the lower end of log 5 on the middle grate finger as shown in Figure 32.
6.Place log 6 into the notch on the top right of log 1 (see Figure 31). Rest the lower end of log 6 on top of log 2B (see Figure 32).
As an option to enhance the look of the hearth, you may place the lava rock provided around the front and sides of the burner pan.
NOTICE: Do not put lava rock inside the burner pan or around the air mixer fitting. Placing lava rock inside the burner pan or blocking the openings of the
Log 5 | Log 6 |
|
Log 1
Notch |
Log 2B |
Figure 31 - Installing Logs 5 and 6
Figure 32 - Logs Installed for M42, M42P, VM42 and VM42P Models
Figure 30 - Installing Logs 3 and 4
16 | www.desatech.com |