INSTALLATION | |
Continued | |
Grate | Pan and Ember |
0.5" | Material |
0.5" |
|
Burner Pan | |
Figure 24 - Pan and Ember Material
Clearances
LOG PLACEMENT FOR M36, M36P, VM36 AND VM36P MODELS
1.Place small front right log (log 1) on right front of grate as shown in Figure 25.
2.Place large back log (log 2) onto grate mak- ing sure notches rest over grate as shown in Figure 25.
3.Place log 3 into notch on log 2, resting the front end on top of log 1 (see Figure 26).
4.Place the upper end of log 4 into the notch on log 2 as shown in Figure 26. Rest the lower end of log 4 onto the middle grate finger as shown in Figure 27.
5.Place the upper end of log 5 into notch on the left of log 2 (see Figure 27). Rest the lower end of log 5 on the grate as shown in Figure 28.
6.Insert the lower end of log 6 between the first two grate fingers as shown in Figure 28 and position the upper end of log 6 into the notched area on the front of log 2 as shown in Figure 28.
As an option to enhance the look of the hearth, you may place the lava rock provided around the front and sides of the burner.
Log 2 
Notch
Log 1
NOTICE: Do not put lava rock inside the burner pan or around the air mixer fitting. Placing lava rock inside the burner pan or blocking the openings of the pro- pane/LP
Log 4
Log 3 Log 2 
Notches
Log 1 |
Figure 26 - Installing Logs 3 and 4 | |
| Log 5 |
Log 6 | Notch |
| Log 4 |
Notch
Figure 27 - Installing Logs 5 and 6
Figure 25 - Installing Logs 1 and 2
Figure 28 - Logs Installed for M36, M36P, VM36 and VM36P Models
www.desatech.com | 15 |