Desa VM42P Opening Vent Damper, Spring, Clip Screw Side Front, Partially Opened Door

Page 18

INSTALLATION

Continued

6.

Repeat the process for the opposite door

 

assembly.

7.

To adjust the doors, slide them partially open.

 

Using a screwdriver, loosen the hold-down

 

screws in the spring clip (see Figure 36) and

 

pivot plate.

8.

Close both doors until evenly joined at the

 

middle and note the gap at the outer edges of

 

the face.

9.

Reopen one door at a time and retighten the

 

upper and lower hold-down screws.

10.

Repeat the process until both doors are evenly

 

joined, spaced and working freely.

Fold Bi-Fold

Door After

Releasing

Spring Clip

and Slide

Door Out of

Upper Track

Spring Clip

Depress Spring Clip to Release Pivot Pin

CAUTION: The glass pan- els become very hot while the appliance is operating. Do not attempt to adjust or clean the glass doors until the appliance has fully cooled.

The doors may be removed for replacement or cleaning as follows:

1.Partially open the door and press up on the upper spring clip with a screw driver until the outer top pivot pin is free of the clip.

2.Fully fold the frame assembly and slide the upper edge towards the center of the firebox opening until the guide pins are free of the frame rail (see Figure 37).

CAUTION: Always operate the appliance with the doors ei- ther fully opened or fully closed. Operating the appliance with the doors partially open can re- sult in improper venting of flue products.

Spring

Hold-Down

Clip

Screw

Side

 

Front

 

Face

 

Partially

 

Opened

 

Door

 

Figure 36 - Adjusting Glass Doors

Remove Bottom Pin

 

From Pivot Plate While

Pivot Plate

Sliding Door Out of the

 

Upper Track

 

Figure 37 - Removing Glass Doors

OPENING VENT DAMPER

Vent damper must be locked in the full open posi- tion before operating the fireplace. If vent damper is not open, fireplace will not light.

 

VENT DAMPER MUST BE LOCKED

 

 

IN THE FULL OPEN POSITION

 

OPEN

TO OPERATE THE APPLIANCE

CLOSE

 

Figure 38 - Opening Vent Damper

18

www.desatech.com

108795-01N

Image 18
Contents Natural GAS PROPANE/LP GASTable of Contents Safety Information High traffic areas Windy or drafty areasBefore YOU Begin UnpackingIntroduction Modification of the appliance or any of the componentsPossible Locations for Installing Appliance Selecting Location10.5 in. WC 2.66 kPa Product SpecificationsM42B,H, VM42B,H Orifice SizeMantel Clearances and Wall PRE-INSTALLATION PreparationClearances DetailsRough Opening for Installing Wall Framingflue connection must be made using listed Venting InstallationInstalling Transition Pipe and Starter Collar Vent Piping Starter Collar Transition Pipe Vent CollarTypical B-Vent Configuration Roof PitchInstallation Wall Switch InstallationChecking for Proper Venting Volt Battery Clip Terminal Wires Receiver Optional Wireless HAND-HELD Remote Control InstallationInstalling Receiver Receiver Plastic Mounting Clips Mounting BracketInstalling 9-Volt Battery in Hand-Held Remote Control Unit GAS Line HOOK-UPM36PB,H M42PB,H Ember and PAN Material Placement Log Notch Log 3 Log Notches LOG Placement for M36, M36P, VM36 and VM36P ModelsGrate Pan and Ember Material Burner Pan LogLog Notches LOG Placement for M42, M42P, VM42 and VM42P ModelsNotch Log Log 2A Log 2B Log Notch Log 2BInstalling Optional Glass Door Accessory Combustion AIR KIT Model AK4 OptionalAppliance Enclosure Clip Screw Side Front Opening Vent DamperSpring Partially Opened DoorFor Your Safety Read Before Lighting Operating FireplaceLighting Instructions To Turn OFF GAS To Appliance Pilot AssemblyInspecting Burners Optional HAND-HELD Remote OperationPilot and Burner Cleaning MaintenanceBurner Flame Pattern LogsTechnical Service Wiring DiagramService Hints Replacement PartsTroubleshooting Observed Problem Possible Cause RemedyIf pilot lights, an improper Connected, replace ignitorElectrode at pilot spark at Gas/air mixture causedGas leak. See Warning Illustrated Parts Breakdown ModelsParts List Description QTYBrick Liners for Models M36B,H, M36PB,H, VM36B,H and VM36PB,HLogsets for Models M42B,H, M42PB,H, VM42B,H and VM42PB,H Accessories Warranty Information Keep this WarrantyLimited Warranty VENT-FREE Firebox