Lighting Procedure
Igniter Lighting System:
1.Check all connections for leaks using the “soapy water” test as explained on page 16.
2.Open the smoker cabinet door.
3.Check for any blockage to the venturi tube or burner. Remove any foreign objects or matter.
4.Be sure the burner control knob is in the “OFF” position.
5.Open the LP cylinder valve
6.To light unit with the igniter, push in and turn the burner control knob
7.Immediately press or rotate the igniter repeatedly to click it several times (you should see a small spark jumping from the end of the electrode rod to the side of the burner). If the burner doesn’t light within 3 to 5 seconds, turn the burner control knob off and wait five minutes before repeating the steps again. If burner still fails to light try match lighting the smoker using the instructions noted below.
8.Once the burner is lit, then close the door to allow heat to accumulate. The dampers can then be adjusted to the desired setting to allow proper air flow and combustion.
Damper adjustment tips are listed on the next page.
Match Lighting:
1.Repeat steps 1 thru 5 of the Igniter Lighting System above.
2.Remove the Wood Chip Box and its stand from inside the smoker. Light a paper match and drop it into the burn chamber, making sure it falls next to the brass burner.
Quickly turn the control knob to the light position. If the burner does not light within 4 or 5 seconds, turn the control knob off, wait 5 minutes, and repeat the process.
21