Sears 20070211 manual HOW to USE Control Panel & Remote Control, To set timer, To use light

ARMADO

PASO 3

Con tornillos Phillips (A), fije el panel de control (6) al cuerpo del ahumador (1).

6

Nota: No los apriete demasiado.

A

PASO 4

Con un tornillo Phillips (A), fije la manilla trasera (7) a la parte posterior del cuerpo del ahumador (1), como se muestra en la ilustración.

NOTA: No levante la unidad por la manija posterior

A

7

A

1

HOW TO USE CONTROL PANEL & REMOTE CONTROL

Note: Direct sunlight may interfere with ability to read LED display, block light if needed.

To set temperature: •Press ON button.

•Press SET TEMP button once-LED display will blink. •Use +/- to set temperature.

•Press SET TEMP button again to lock in temperature. Note: Heating will not begin until timer is set.

To set timer:

•Press SET TIME button once-LED display for hours will blink. •Use +/- to set hours.

•Press SET TIME button again to lock in hours. The minutes LED will start blinking. •Use +/- to set minutes.

•Press SET TIME to lock in minutes and start cook cycle.

Heat will turn off when time has expired.

To use meat probe:

•Insert meat probe into center of meat to get most accurate reading.

•Press and hold MEAT PROBE button-LED display will show internal temperature of meat.

•Once MEAT PROBE button is released-LED display will return to set temperature or set time.

To use light:

•Press LIGHT button to turn light on.

•Press LIGHT button to turn light off.

To RESET control panel:

If control panel shows an error message, turn electric smoker off, unplug unit from outlet, wait ten seconds, plug unit back into outlet, then turn electric smoker on. This will reset control panel.

7 12