NORMAL OPERATION
Main Burner Snap Ignition
Note: Each control knob snap igniter creates a spark from the igniter electrode to the burner lighting tube. You generate the energy for the spark by pushing in the control knob and turning to “START/HI”. This will ignite each individual burner.
Follow the simple steps listed below to light the Main Burner(s) of your grill:
1.Open the lid and make sure that all burners are in the “OFF” position.
2.Turn main gas supply on.
3.Push the control knob in and turn to “START/HI” until you hear the igniter snap - continue to hold control knob in for two seconds. This action will spark the igniter, the burner lighting tube and then main burner.
4.Check that the burner is lit by looking through the cooking grates. You should see a flame. If burner does not light on first try, push control knob in and turn to OFF.
WARNING: If ignition still does not occur, turn control knob OFF and wait 5 minutes before manually lighting the burner with match. See Match Lighting instructions.
1 | 4 | 3 |
1 
4 |
2
1 | 3 |
15