Side Burner Snap Ignition

NORMAL OPERATION

Note: Each control knob snap igniter creates a spark from the igniter electrode to the burner lighting tube. You generate the energy for the spark by pushing in the control knob and turning to “START/HI”. This will ignite each individual burner.

Follow the simple steps listed below to light the Side Burner (SB) of your grill:

	DANGER: Failure to open the lid while igniting the side
	burner, or not waiting 5 minutes to allow the gas to clear
	if the side burner does not light, may result in a explosive	HI
	flame-up which can cause bodily injury or death.	HI
	flame-up which can cause bodily injury or death.

1.Open the lid and make sure that all burners are in the “OFF” position.

2.Turn main gas supply on.

3.Push the control knob in and turn to “START/HI” until you hear the igniter snap - continue to hold control knob in for two seconds. This action will spark the igniter, the burner lighting tube and then side burner.

4.Check that the burner is lit by looking through the cooking grates. You should see a ﬂame. If burner does not light on ﬁrst try, push control knob in and turn to OFF. Repeat lighting procedure a second time.

5.Verify Side Burner has ignited by visual inspection of a ﬂame.

WARNING: If ignition still does not occur, turn control knob OFF and wait 5 minutes before manually lighting the burner with match. See Match Lighting instructions.

Match Lighting Your Grill Side Burner

Follow the simple steps listed below to match light the Side Burner of grill, in the event snap ignition fails:

1. Open the lid and make sure that all burners are in the “OFF” position.

DANGER: Failure to open the lid while igniting the Side Burner, or not waiting 5 minutes to allow the gas to clear if the Side Burner does not light, may result in an explosive flame-up which can cause bodily injury or death.

2. Turn main gas supply on.

3. Put match in the match holder and strike match.

WARNING: Do not lean over an open barbecue.

4.Push in Side Burner control knob and turn to “high”.

5.Insert match holder and lit match through trivet to ignite the Side Burner.

WARNING: If burner does not light, turn the Side Burner control knob to OFF and wait 5 minutes to let the gas clear before trying again to light burner.

6.Verify Side Burner has ignited by visual inspection of a ﬂame.

OFF / ARRÊTÉ / APAGADO

1 4

	P
	U
	S
	H
3		T
3		O
		T
		U
	N	R
	N

SIDE BURNER

14	www.ducane.com