Ducane 20529917 owner manual Main Burner Snap Ignition, Match Lighting Your Grill Main Burners

NORMAL OPERATION

Main Burner Snap Ignition

Note: Each control knob snap igniter creates a spark from the igniter electrode to the burner lighting tube. You generate the energy for the spark by pushing in the control knob and turning to “START/HI”. This will ignite each individual burner.

Follow the simple steps listed below to light the Main Burner(s) of your grill:

1.Open the lid and make sure that all burners are in the “OFF” position.

2.Turn main gas supply on.

3.Push the control knob in and turn to “START/HI” until you hear the igniter snap - continue to hold control knob in for two seconds. This action will spark the igniter, the burner lighting tube and then main burner.

4.Check that the burner is lit by looking through the cooking grates. You should see a flame. If burner does not light on first try, push control knob in and turn to OFF.

WARNING: If ignition still does not occur, turn control knob OFF and wait 5 minutes before manually lighting the burner with match. See Match Lighting instructions.

Match Lighting Your Grill Main Burners

Follow the simple steps listed below to match light the Main Burner(s) of grill, in the event snap ignition fails:

WARNING: (Make sure that 5 minutes have elapsed since last attempt of lighting.) Make sure that the lid is in the full open position any time you attempt to light your grill. Failure to open the lid could lead to delayed ignition which may result in serious bodily injury or death, or in a fire or an explosion causing damage to property.

WARNING: Do not lean over an open barbecue.

1. Open the lid and make sure that all burners are in the “OFF” position.

DANGER: Failure to open the lid while igniting the main burners, or not waiting 5 minutes to allow the gas to clear if the main burner(s) does not light, may result in an explosive flame-up which can cause bodily injury or death.

2.Turn main gas supply on.

3.Put match in the match holder and strike match.

4.Push in selected MAIN BURNER control knob and turn to “HIGH”.

5.Insert match holder and light match down through cooking grate to ignite the selected Main Burner.

WARNING: If the burner does not light, turn the selected burner control knob to OFF and wait 5 minutes to let the gas clear before trying again to light burner(s).

6. Verify selected Main Burner(s) has ignited by visual inspection of a flame.

OFF / ARRÊTÉ / APAGADO

LO

MAIN BURNER