Aussie 68R5A9SSS1 manual Step Door Assembly, Step Hood/Body To Cart Assembly

Page 10

10

Step 10

Door Assembly

Install LEFT Door. Drop bottom door pin into Cabinet Bottom Panel hole. Swing top of door toward hole in top of Left Side Panel. Depress spring-loaded pin with thumb while sliding pin into Left Side Panel hole until it snaps into place.

Right Door assembly is similar; Fixed pin is under drawer and inserts into hole in door and spring-loaded pin is in the BOTTOM of small door and functions the same.

Depress

Left Door shown, Right Door under drawer.

!CAUTION

To reduce the risk of bodily injury from lifting, the following assembly steps #s 11 and 12 will require two people.

Step 11

Hood/Body To Cart Assembly

Lift the Hood/Body Assembly over the cart assembly and set it down until it rests on the inside top flanges of the cart.

Align the holes in the side of the Hood/Body with the holes in the Side Panel brackets. Insert four 1/4-20 x .50 Bolts through the holes in cabinet flanges and into threaded inserts in firebox and tighten after all are installed.

1/4-20 x .50” Bolt set

4 pc

Right side view

NOTE:

Carefully route gas and electrical lines when plac- ing hood/body assembly on cart. Be sure no lines are pinched between hood/body assembly and cart.

Image 10
Contents LP Gas Grill Assembly and Use Manual 68R5A9SSS1Tools Required for Assembly Supplied with Grill Carbon Monoxide HazardPacking List DescriptionContents Preparation for AssemblyStep Caster Assembly Assembly InstructionsStep Cabinet Bottom Assembly Step Side Panel Assembly Step Cabinet Upright Assembly Step Front Crossbar AssemblyFront Corner Bracket Assembly Cylinder Blocking Wire Assembly Step Back Panel Brace wire AssemblyStep Door Handle Assembly Step Drawer Assembly Drawer PositioningStep Door Assembly Step Hood/Body To Cart AssemblyStep Side Table Assembly Step Side Burner Valve Assembly Step Side Burner Igniter Wire ConnectionStep Bottom Body Panel Assembly Step Side Burner Control Knob AssemblySide Burner Grid Assembly Foil Pan/Grease Pan AssemblyStep Warming Rack Assembly Step Flavor Activator/Cooking Grid AssemblyStep Battery in Igniter Installation StorageUsing Gas Connecting/Disconnecting the GasLP Gas Cylinder Disconnecting LP Gas Cylinder Connecting LP Gas CylinderLP Hose and Regulator Selecting a Location Before Using Your LP Gas GrillInstallation Codes Performing a Leak TestHow to Perform a Leak Test First Time USE and as required Replace the control panel in the same Lighting the Grill Using the Pulse-Spark Ignitor Control Knob Lighting the Rotisserie Burner Manually Lighting the Grill Check The Flame Lighting the Side BurnerManually Lighting the Side Burner Manually Lighting the Side Burner Manually Lighting the Rotisserie BurnerCooking On the Gas Grill Grill Cooking Direct MethodDirect Cooking on the Grids Roasting Indirect MethodIndirect Cooking Roasting Poultry Rotisserie CookingRotisserie Cooking Leg of LambWarming Rack End of Cooking SessionCare and Maintenance Cleaning the GrillHow to Clean the Burners Open up Troubleshooting EmergenciesMaintenance Clean the Burners. See How to Clean Burners in CareSee How to Clean Burners in Care and Maintenance Then stops when full Rises up while fillingPage Parts List- Model Key Description QuantityParts Illustrations- Model Limited Warranty Meco Corporation