Aussie 68R5A9SSS1 manual Lighting the Grill Using the Pulse-Spark Ignitor

Page 21

21

8.If “growing” bubbles appear on any of the connection points, you have detected a gas leak. Immediately close the LP Gas Cylinder valve by turning handle clockwise

a.If leak appears at either end of hose and regulator assembly, retighten the connection at the leak, but do not over-tighten. (NOTE: Only hand tighten at coupling nut in Fig. 3 shown on previous page) Repeat Leak Test.

b.If the leak is coming from the Gas Cylinder, from the valves at the Control Knobs, or if the leak cannot be stopped, do not use the grill. Call Customer Service at 1-800-251-7558. Be sure to have the grill model number and serial number printed on the black label, located inside the left door of the cabinet. If you need a replacement part under warranty, a proof of purchase will be necessary.

9.Upon completion of leak test, turn all Control Knobs to the “Off” position. Turn the handle on the LP Gas Cylinder clockwise until it stops. Disconnect LP Gas Cylinder by turning coupling nut on regulator in a counterclockwise direction until regulator is released from threaded LP Gas Cylinder nozzle.

10.Place the protective cap over LP Gas Cylinder nozzle.

11.Re-attach the wire leads to the Igniter Button. Replace Control Panel around flanges at Bowl ends and align bolt holes on each side. Replace and retighten all bolts. (Fig. 1)

Lighting the Grill Using the Pulse-Spark Ignitor

!WARNING

To reduce the risk of death or serious injury from an explosion or a fire beneath the grill:

Inspect and clean Burner/Venturi Tubes for insects or insect nests. Spiders or small insects can build nests, webs, and lay eggs in the grill’s Venturi Tubes, (Fig 15 - page 31) obstructing the flow of gas to the Burner. The backed-up gas can ignite behind the Control Panel and cause a fire beneath the grill, posing the risk of death or serious bodily injury. This is known as a “flashback.”

Be sure Burners are re-installed properly before using grill.

Should you notice that your Burner(s) are getting hard to light or the flame is not as hot as it once was, refer to the “How to Clean your Burners” section on page 31, to remove any possible obstructions.

Image 21
Contents 68R5A9SSS1 LP Gas Grill Assembly and Use ManualCarbon Monoxide Hazard Tools Required for Assembly Supplied with GrillDescription Packing ListPreparation for Assembly ContentsAssembly Instructions Step Caster AssemblyStep Cabinet Bottom Assembly Step Side Panel Assembly Step Front Crossbar Assembly Step Cabinet Upright AssemblyFront Corner Bracket Assembly Step Back Panel Brace wire Assembly Cylinder Blocking Wire AssemblyStep Door Handle Assembly Drawer Positioning Step Drawer AssemblyStep Hood/Body To Cart Assembly Step Door AssemblyStep Side Table Assembly Step Side Burner Igniter Wire Connection Step Side Burner Valve AssemblySide Burner Grid Assembly Step Side Burner Control Knob AssemblyStep Bottom Body Panel Assembly Foil Pan/Grease Pan AssemblyStep Flavor Activator/Cooking Grid Assembly Step Warming Rack AssemblyStorage Step Battery in Igniter InstallationConnecting/Disconnecting the Gas Using GasLP Gas Cylinder Connecting LP Gas Cylinder Disconnecting LP Gas CylinderLP Hose and Regulator Installation Codes Before Using Your LP Gas GrillSelecting a Location Performing a Leak TestHow to Perform a Leak Test First Time USE and as required Replace the control panel in the same Lighting the Grill Using the Pulse-Spark Ignitor Control Knob Lighting the Rotisserie Burner Manually Lighting the Grill Lighting the Side Burner Check The FlameManually Lighting the Side Burner Manually Lighting the Rotisserie Burner Manually Lighting the Side BurnerGrill Cooking Direct Method Cooking On the Gas GrillRoasting Indirect Method Direct Cooking on the GridsIndirect Cooking Roasting Rotisserie Cooking Rotisserie CookingPoultry Leg of LambEnd of Cooking Session Warming RackCleaning the Grill Care and MaintenanceHow to Clean the Burners Open up Emergencies TroubleshootingClean the Burners. See How to Clean Burners in Care MaintenanceSee How to Clean Burners in Care and Maintenance Rises up while filling Then stops when fullPage Key Description Quantity Parts List- ModelParts Illustrations- Model Meco Corporation Limited Warranty