Aussie 68R5A9SSS1 manual Manually Lighting the Grill

Page 24

24

Manually Lighting the Grill

!WARNING

To reduce the risk of serious bodily injury or death from fire or explosion:

• Open Hood before lighting the grill to prevent an explosion from gas build-up.

1.Open the Hood.

2.IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 7)

3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 8)

4.Locate either the left or right match-lighting hole you intend to use underneath the Grill Bowl. Push in and turn either the far left or far right Main Burner Control Knob, near the match-lighting hole, counterclockwise to the “High” position.

5.Insert a lit match through the match-lighting hole using the match holder (Fig. 11 and 11a) OR through the cooking grates. (Fig. 12)

View from underneath. Insert lit match through match lighting hole under the left side burner table using the match light holder

Fig. 11

View of match through hole from top side of burner. Shown without Flavor Activators and

cooking grids.

Fig. 11a

View of inserting lit match through the cooking grids. Each burner may be lit in succession in this method if necessary.

Fig. 12

6.From the “Off” position, light all other Burners from left or right, making sure each Burner is lit before lighting the next. Your grill has a Crossover Ignition System that allows the Burners to light successively off one another. Confirm each Burner is lit before lighting another Burner.

If any or all Burners fail to light after three or four attempts following Steps 3-5, turn all Control Knobs to the “Off” po- sition and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then repeat the lighting procedures.

NOTE: If the Burner still fails to light, refer to the Troubleshooting Section.

7.After ignition, turn the Control Knobs to “High” for 3-5 minutes and close the Hood to preheat the grill. Preheat the grill before every cooking session.

If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve to dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill.

Image 24
Contents LP Gas Grill Assembly and Use Manual 68R5A9SSS1Tools Required for Assembly Supplied with Grill Carbon Monoxide HazardPacking List DescriptionContents Preparation for AssemblyAssembly Instructions Step Caster AssemblyStep Cabinet Bottom Assembly Step Side Panel Assembly Step Front Crossbar Assembly Step Cabinet Upright AssemblyFront Corner Bracket Assembly Step Back Panel Brace wire Assembly Cylinder Blocking Wire AssemblyStep Door Handle Assembly Step Drawer Assembly Drawer PositioningStep Door Assembly Step Hood/Body To Cart AssemblyStep Side Table Assembly Step Side Burner Valve Assembly Step Side Burner Igniter Wire ConnectionStep Side Burner Control Knob Assembly Side Burner Grid AssemblyStep Bottom Body Panel Assembly Foil Pan/Grease Pan AssemblyStep Warming Rack Assembly Step Flavor Activator/Cooking Grid AssemblyStep Battery in Igniter Installation StorageConnecting/Disconnecting the Gas Using GasLP Gas Cylinder Connecting LP Gas Cylinder Disconnecting LP Gas CylinderLP Hose and Regulator Before Using Your LP Gas Grill Installation CodesSelecting a Location Performing a Leak TestHow to Perform a Leak Test First Time USE and as required Replace the control panel in the same Lighting the Grill Using the Pulse-Spark Ignitor Control Knob Lighting the Rotisserie Burner Manually Lighting the Grill Lighting the Side Burner Check The FlameManually Lighting the Side Burner Manually Lighting the Side Burner Manually Lighting the Rotisserie BurnerCooking On the Gas Grill Grill Cooking Direct MethodRoasting Indirect Method Direct Cooking on the GridsIndirect Cooking Roasting Rotisserie Cooking Rotisserie CookingPoultry Leg of LambWarming Rack End of Cooking SessionCare and Maintenance Cleaning the GrillHow to Clean the Burners Open up Troubleshooting EmergenciesClean the Burners. See How to Clean Burners in Care MaintenanceSee How to Clean Burners in Care and Maintenance Then stops when full Rises up while fillingPage Parts List- Model Key Description QuantityParts Illustrations- Model Limited Warranty Meco Corporation