Aussie 68R5A9SSS1 manual Step Side Burner Valve Assembly, Step Side Burner Igniter Wire Connection

Page 12

12

Step 13

Side Burner Valve Assembly

NOTE: Side Burner Valve is already attached to the regulator hose. Hose is not shown in some illustrations for clarity.

A. Install the Side Burner Valve from underneath the LEFT Side Table. Remove the screws from the side burner bracket and set aside with bracket.

B. Tilt venturi end of burner down and slide rectangular venturi windscreen toward back of grill to expose open end of burner tube.

C. Insert the valve stem out through the hole in the bezel and fascia on the front of the side table. Next insert the nozzle into the opening in the burner tube.

D. Attach the valve to the front of the side table by installing two 5/32” x .31” Bolts through the Control Knob Bezel and front of the Side Table into the threaded Valve bracket holes. Slide the windscreen back into position and replace the side burner bracket.

5/32 x .31” Bolt

2 pc

Side Burner

Bracket

A

Valve

Venturi Windscreen

C

B

Step 14

Side Burner Igniter Wire Connection

The Side Burner Igniter Wire is pre-installed and connected to the Ignition Box. Attach the wire to the Side Burner electrode by sliding the wire connector onto the electrode terminal.

Underside view of

Side Table/Side Burner

D

Note:

Shown without Regulator Hose for clarity.

Image 12
Contents LP Gas Grill Assembly and Use Manual 68R5A9SSS1Tools Required for Assembly Supplied with Grill Carbon Monoxide HazardPacking List DescriptionContents Preparation for AssemblyAssembly Instructions Step Caster AssemblyStep Cabinet Bottom Assembly Step Side Panel Assembly Step Front Crossbar Assembly Step Cabinet Upright AssemblyFront Corner Bracket Assembly Step Back Panel Brace wire Assembly Cylinder Blocking Wire AssemblyStep Door Handle Assembly Step Drawer Assembly Drawer PositioningStep Door Assembly Step Hood/Body To Cart AssemblyStep Side Table Assembly Step Side Burner Valve Assembly Step Side Burner Igniter Wire ConnectionStep Side Burner Control Knob Assembly Side Burner Grid AssemblyStep Bottom Body Panel Assembly Foil Pan/Grease Pan AssemblyStep Warming Rack Assembly Step Flavor Activator/Cooking Grid AssemblyStep Battery in Igniter Installation StorageConnecting/Disconnecting the Gas Using GasLP Gas Cylinder Connecting LP Gas Cylinder Disconnecting LP Gas CylinderLP Hose and Regulator Before Using Your LP Gas Grill Installation CodesSelecting a Location Performing a Leak TestHow to Perform a Leak Test First Time USE and as required Replace the control panel in the same Lighting the Grill Using the Pulse-Spark Ignitor Control Knob Lighting the Rotisserie Burner Manually Lighting the Grill Lighting the Side Burner Check The FlameManually Lighting the Side Burner Manually Lighting the Side Burner Manually Lighting the Rotisserie BurnerCooking On the Gas Grill Grill Cooking Direct MethodRoasting Indirect Method Direct Cooking on the GridsIndirect Cooking Roasting Rotisserie Cooking Rotisserie CookingPoultry Leg of LambWarming Rack End of Cooking SessionCare and Maintenance Cleaning the GrillHow to Clean the Burners Open up Troubleshooting EmergenciesClean the Burners. See How to Clean Burners in Care MaintenanceSee How to Clean Burners in Care and Maintenance Then stops when full Rises up while fillingPage Parts List- Model Key Description QuantityParts Illustrations- Model Limited Warranty Meco Corporation